Needle Valve Kit
#1
Needle Valve Kit
I bought a needle valve kit for my HSK850 Tecumseh carb cause the spring was broken
Problem is the new spring seems shorter than the old one which
seemed to have been wrapped around the pin holding the float in place
(or not?
It's easy to see how the spring attaches to the needle valve but does anyone have a pic of how the other end is supposed to be?
Regards
fabe317@yahoo.com
Problem is the new spring seems shorter than the old one which
seemed to have been wrapped around the pin holding the float in place
(or not?
It's easy to see how the spring attaches to the needle valve but does anyone have a pic of how the other end is supposed to be?
Regards
fabe317@yahoo.com
#2
Hello fabe317, try this link, I hope you can see it because I had to use a photo editor to see it clearly.....Mike
http://www.kidskartclub.org/Misc%20p...spring_WEB.jpg
http://www.kidskartclub.org/Misc%20p...spring_WEB.jpg
#3
Hello fabe317!
In case you can't see the picture, the clip goes on the needle, and the long end of the wire just goes over the tab on the float. It does not wrap around anything, and you don't bend it or anything.
In case you can't see the picture, the clip goes on the needle, and the long end of the wire just goes over the tab on the float. It does not wrap around anything, and you don't bend it or anything.
#4
Needle Valve Kit
To MikejMerrit and Cheese, thanx a lot
Yer aid was right on
I hate to waste the bandwidth but I hav to say praise be to the internet and to guys like you who help others
Years ago you could not get this kind of help without spending a small fortune
Yer aid was right on
I hate to waste the bandwidth but I hav to say praise be to the internet and to guys like you who help others
Years ago you could not get this kind of help without spending a small fortune