B&S Needle and Seat

Reply

  #1  
Old 05-30-04, 09:36 PM
michaelshortt's Avatar
Forum Topic Moderator
Thread Starter
Join Date: Mar 2002
Location: Washington State
Posts: 788
B&S Needle and Seat

Have ordered a carb kit and float for my Pressure washer Briggs and Stratton engine 6HP OHV. Mdl 120612 0132. Runs OK but while sitting gas keeps flowing through the carb. When I had it apart I could not see the seat. It must be there, but wondering how I remove it and install the new one.
 
Sponsored Links
  #2  
Old 05-31-04, 12:37 AM
repair_guy's Avatar
New Member
Join Date: Apr 2004
Location: Marion,Al.
Posts: 539
You can blow it out with compressed air by puting air gun to fuel line nipple or pull it out useing a small crochet needle.Make sure in puting the new one in that the rings on it point towards carb.
 
  #3  
Old 06-01-04, 07:49 PM
michaelshortt's Avatar
Forum Topic Moderator
Thread Starter
Join Date: Mar 2002
Location: Washington State
Posts: 788
Thanks repair guy. Did the repair today. Looks like the outside ring was a little distorted and was not sealing on the bottom of the hole. I think it has always leaked since I got it. In my new garage with a natural gas heater it made me a little nervous. No leak so far, guess time will tell.
 
  #4  
Old 06-02-04, 02:22 AM
repair_guy's Avatar
New Member
Join Date: Apr 2004
Location: Marion,Al.
Posts: 539
Whoooooh, sounds like it could've been a very nasty seine!Glad I could help.
 
Reply

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are Off
Pingbacks are Off
Refbacks are Off


Thread Tools
Search this Thread
Display Modes