Flywheel removal and installation HELP for a Briggs & Stratton 12 HP

Reply

  #1  
Old 07-04-04, 11:59 AM
Eddiemann
Visiting Guest
Posts: n/a
Arrow I Need Help Removing Plastic Ring Gear from the Flywheel

Could someone please tell me how to remove a Plastic Ring Gear off the flywheel?

Thank You:
Eddiemann
 

Last edited by Eddiemann; 07-04-04 at 01:14 PM. Reason: Wrong thing
Sponsored Links
  #2  
Old 07-04-04, 10:56 PM
sceptre
Visiting Guest
Posts: n/a
first take the flywheel off the engine. then use a small center punch to make a indention in the four pins on the fin side. use a 1/8 drill bit make a hole about 1/8 inch deep. change bit to 1/4 drill bit then drill till the brad end is removed. use a 3/16 pin punch to drive out the pins. install the new replacement ring gear according to instructions. the new gear will be aluminum, it should last the remainder of the engine's life. i've replaced several of these and this is how i do it.

later,
 
Reply

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are Off
Pingbacks are Off
Refbacks are Off


Thread Tools
Search this Thread
Display Modes