DoItYourself.com Community Forums > Cars, SUV's, Vans, Trucks, RV's, Boats and Gasoline Outdoor Power Equipment > Outdoor Gasoline and Electric Powered Equipment and Small Engines

Remington sl9

Thread Tools

Search this Thread

01-28-06, 10:00 PM

Jerbear

Member

Thread Starter

Join Date: Aug 2005

Posts: 43

Upvotes: 0

Received 0 Upvotes on 0 Posts

Remington sl9

Hi, I have acquired an old Remington SL9 51cc chainsaw. It needs an new pull rope ratchet as it does not catch and will not turn motor over. Any ideas where I might find parts for this chainsaw. Any ideas appriciated. Jerbear

Upvote

01-29-06, 09:54 PM

cheese

Forum Topic Moderator

Join Date: Jul 2001

Location: USA

Posts: 15,883

Upvotes: 30

Received 131 Upvotes on 121 Posts

I've seen parts for them on ebay.

Upvote

01-29-06, 10:38 PM

Jerbear

Member

Thread Starter

Join Date: Aug 2005

Posts: 43

Upvotes: 0

Received 0 Upvotes on 0 Posts

Thanks, Cheese, I will check it out. Regards, jerbear.

Upvote

Thread Tools

Search this Thread

Show Printable Version

Email this Page

Outdoor Gasoline and Electric Powered Equipment and Small Engines
String Trimmer Won't Pull or Start

Z

zzanath on Jan 28, 2006

I’ve had a Troy-Bilt 2-cycle string trimmer model TB75SS for a little over two years (just past the warranty…). Recently I was using it when the engine cut out. On trying to restart it, the pull start was much more difficult to pull and I couldn’t get it going. After doing all of the normal maintenance checking, I brought it in for repair and was told that the “ignition coil (?), starter rope, air filter and spark plug” needed to be replaced for a total of $100. Not only is this almost the price of a new one, but I didn’t think that was the problem to begin with, so I didn’t have it serviced. I now have it partially taken apart. I’ve noticed that with the spark plug out, the pull start is easy to pull and the cylinder moves fine. It’s only with the spark plug in or when I’m blocking the plug hole does it become extremely difficult to pull. I have the muffler off, so it isn’t that or the spark arrest screen being clogged. I’ve also tried cleaning inside the cylinder with carb cleaner and soaking it briefly with oil, all with no luck. Any ideas or help would be greatly appreciated…Read More
Outdoor Gasoline and Electric Powered Equipment and Small Engines
Craftsman 46" deck mandrel

E

electech on Jan 23, 2006

I have a craftsman mower with a 46 " deck. Bearings keep going bad in the mandrels(spindle). Does anyone know the size of these bearings, they should be cheaper than buying the whole assy. ThanksRead More

Ask a Question