DoItYourself.com Community Forums > Cars, SUV's, Vans, Trucks, RV's, Boats and Gasoline Outdoor Power Equipment > Outdoor Gasoline and Electric Powered Equipment and Small Engines

Stanley push mower elec. start not working

Thread Tools

Search this Thread

05-09-07, 10:46 AM

drbillc

Member

Thread Starter

Join Date: May 2007

Location: Fenton, MO

Posts: 2

Upvotes: 0

Received 0 Upvotes on 0 Posts

Stanley push mower elec. start not working

I have a 2003 Stanley push mower (re-branded Murray) with the LEV120 motor on it and both electric and rope start. The mower starts up right away with the rewind/rope start but won't turn over or even make a noise with the electric start. I replaced the battery hoping that this would do it but no dice. Is this likely the solenoid? Any help is greatly appreciated!

Upvote

05-09-07, 06:34 PM

puey61

Member

Join Date: Apr 2004

Location: Upstate New York

Posts: 2,903

Upvotes: 0

Received 2 Upvotes on 2 Posts

A push mower doesn't have a solenoid. You'll need a test light or Ohms meter to diagnose and pinpoint your area of trouble.

Upvote

Thread Tools

Search this Thread

Show Printable Version

Email this Page

Outdoor Gasoline and Electric Powered Equipment and Small Engines
Wrong Ext Cord Blowing Out Motors?

B

bheron on May 08, 2007

I apologize if you think this should be in the Electrical forum (if so, let me know). In 2005 I purchased an electrical trimmer and 100' ext cord from Sears at the same time. Used it fine until it just stopped working last summer. I was secretly glad b/c I wanted to upgrade. Today, I purchased another electrical trimmer, Ryobi Brand, and 5 mins into my first usage it, too, stopped working. Im prepared to return the trimmer, but I realized I used the same 100' ext cord as before. I looked a little closer and see that the 100' cord is 14 guage wire. The owners manual of my trimmer says the standard for a 100' should be 12 gauge. Could this have caused either or both trimmers to blow out?Read More
Outdoor Gasoline and Electric Powered Equipment and Small Engines
Old Ariens Snow-Thro

U

UpstateRanger on May 10, 2007

Long of the short...been reading through posts trying to see if I can't figure some of this out myself...Haven't quite seen what I need, so I'm making this thread...apologies to the long time members, but I'm a newbie here, and at doing stuff myself... I picked up an old Ariens Snow-Thro free by the side of the road...the owner said he had used it a two of years ago, but not this last winter due to a leg injury...Here's some of the serial numbers I found on it: Engine: Tecumsah Model: H60-75003B (may be a 3 or 8? couldn't quite read it) Serial #: 3248 04599 (again, the 3 may be a different number...hard to tell) The Ariens part has two set's of numbers: Ser. # 10ML60 - 18125 and on the chute part: 7-10M 32359 Here's what I'd like to know: Approximate age (mid to late 1960's??)? (Anywhere on the web to find a manual?) Would it hurt to throw some gas in it and just try to fire it up? (oil is level is good) or could I damage the motor? Was looking for parts on PartsRadar (linked from Ariens website), and can't figure out what machine I have in front of me...I typed in 10ML60 and got four machines, none of which match the last part of the serial number I have (number above). Anyone help me there? Machine/engine pretty dirty...would it hurt it to take a power washer to it all? The guy I got it from said the carb. spits fuel after running a while...from the looks of it, that's a fairly common problem/fairly easy fix...I've never worked with small engines like this...it was free...would you advise me to get the parts and try fixing it myself? Or is it old enough that I should have a shop look at it? If I can get it up and running...a coat of orange paint? What kind/color? Again...completely new at this small engine thing...thought I might have a diamond in the rough here for nothing...(and not looking to put tons of money into it) But of course, know it'll cost something...is this worth trying to fix? What do you all think?Read More

Ask a Question