12.5 B&S Black Coil wire connection
#1
Member
Thread Starter
Join Date: May 2007
Location: ottawa
Posts: 11
Upvotes: 0
Received 0 Upvotes
on
0 Posts
12.5 B&S Black Coil wire connection
I rebuilt my B%S 12.5 Engine model 282707-0116 and I can't remember where to connect the black wire from the coil. I was able to start it and shut it off by grounding this wire but I need to hook it up properly. Can anyone give pointer where to connect this black wire with a small ring terminal at one end.
Al
Al
#2
usually you connect the black wire from the coil to the connector on the throttle control plate. Most of these plates have a clip the wire goes into and some even will ground out the coil when the throttle is pulled past low idle.
#3
Member
Join Date: Dec 2006
Location: Central Indiana
Posts: 100
Upvotes: 0
Received 0 Upvotes
on
0 Posts
Look around where throttle cable hooks to engine, there will be a kill switch located in that area. Wire hooks to it. There will be a wire coming from key switch that goes to one side of kill switch.