My 9hp Craftsmen snowblower won't throw snow the impeller gets clogged and I chaged the belt but it didn't make a difference. Both shear pins are fine and the auger spins. I am wondering if it is something in the gear box or if there is a keyway on one of the shafts where the pullies are. Any suggestions? :wall:

Hi, I bought the referenced pressure washer from Amazon. After plugging the hose, etc, I made a test. The motor started to charge pressure, water supply was ok and working, and it took a while until I pressed the trigger to check the water flow. Immediately, it started to leak water in the base (like a fine shower from a gasket, under the cover) and at the same time, water was able to get through with let's say 30% of the real pressure (PSI 1600!!) What could it be? would it be worst to check the gasket by my own or take it to the service? (no warranty available) is this usual in this model?:confused: thanks for any guidance Mx