Honda Power Washer GC160 - pressure on and off
#1
Member
Thread Starter
Join Date: Apr 2008
Posts: 1
Upvotes: 0
Received 0 Upvotes
on
0 Posts
Honda Power Washer GC160 - pressure on and off
I haven't used this washer in a year or more. It starts right up and it produced pressure for a while. After turning off, I can no longer get any pressure out of the spray (it is in the pressure position). Water is flowing normally in the un-pressurized position. Please give me any suggestions. The power washer is 5 years old, but only has about 30 hours, if that. Thanks.
#2
I'd say the unloader vlave is stuck, and needs to be pulled out, cleaned up, and clean the bore in which it fits. Lube the o-ring(s) on it and put it back together and see where that gets you.