Shindaiwa 575
#1
Member
Thread Starter
Join Date: Aug 2008
Location: West By God Virginia
Posts: 3
Upvotes: 0
Received 0 Upvotes
on
0 Posts
Shindaiwa 575
I have an older model 575 that sat for many years. I've replaced the fuel pickup, cleaned the fuel filter and tank, cleaned the carb, installed a diaghram (?) kit and set the hi/lo speed adjustment needles.
The saw runs great for the first couple of minutes but begins to stall out or flood when it warms up. I can turn the saw upside down and hold it over my head when it begins to stall and it begins to run again.
Anyone come across this problem before?
The saw runs great for the first couple of minutes but begins to stall out or flood when it warms up. I can turn the saw upside down and hold it over my head when it begins to stall and it begins to run again.
Anyone come across this problem before?
#3
I would check the fuel pump pulse hose make sure there are not cracks and that is not too soft, make sure the connections at the carburetor and crankcase are good and snug. Check the carburetor mtg boot for integrity as well.
Good Luck...
Good Luck...