Old 08-01-09, 05:36 PM
Thread Starter
Join Date: Aug 2009
Location: Massachusetts
Posts: 1

I have a Sear chain saw 16" bar 2.4 cc that will only run when held on it's side. I push the priming bulb and it starts , if I hold it flat it runs out of gas and stalls.If I hold it on it side it runs fine. Any suggestions would be appreciated. Thanks Jim
Sponsored Links
Old 08-01-09, 06:25 PM
Join Date: Jul 2009
Location: california
Posts: 10
lol, just a thought is the tank full?
Old 08-01-09, 08:40 PM
cheese's Avatar
Forum Topic Moderator
Join Date: Jul 2001
Location: USA
Posts: 16,822
Did you recently replace the fuel lines?

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are Off
Pingbacks are Off
Refbacks are Off

Thread Tools
Search this Thread
Display Modes