DoItYourself.com Community Forums > Cars, SUV's, Vans, Trucks, RV's, Boats and Gasoline Outdoor Power Equipment > Outdoor Gasoline and Electric Powered Equipment and Small Engines

Weedeater fl20, 2008 carb, 711794

Thread Tools

Search this Thread

10-21-09, 12:01 PM

ROAD-KING

Member

Thread Starter

Join Date: Oct 2009

Location: GROVETOWN, GA., 30813-4119

Posts: 1

Upvotes: 0

Received 0 Upvotes on 0 Posts

Weedeater fl20, 2008 carb, 711794

HELP! SEEMS THAT I AM NOT GETTING GAS TO CARB...I'M OPEN FOR ANY IDEAS...I'VE CLEANED, LOOKED AT, STILL I CANNOT SEE ANY REASON THAT I AM NOT GETTING GAS...

NOW THE BULB DOES NOT FILL BACK UP (PRIMER)...

Upvote

10-21-09, 02:31 PM

geogrubb

Member

Join Date: Jun 2006

Location: United States

Posts: 2,277

Upvotes: 0

Received 28 Upvotes on 27 Posts

Sounds like the fuel lines are bad and may have separated in the tank. Have a good one. Geo

Upvote

Thread Tools

Search this Thread

Show Printable Version

Email this Page

Outdoor Gasoline and Electric Powered Equipment and Small Engines
Cannot Remove Blade Bolt

R

roy overthehill on Oct 04, 2009

I have a seven year old Toro 22" Recycler front-drive walk behind mower model no. 20016. Last week I tried to remove the blade to replace it and the bolt would not budge. I blocked the blade with a length of 4x4 to keep it from moving but the crankshaft turned instead. The last time I sharpened the blade, less than two months ago, I torqued it to 60 ft/lbs. I have a two-foot long 1/2" drive breaker bar that I can try on it, by jerking it, but I'm worried I will just wring off the head of the bolt. How strong are the blade bolts? The only way I see to get to the shaft to stop it from turning is from the top by blocking the starter cup or the flywheel. Anyone else had this problem and have a solution? I'm still mowing with the old blade, but I need to replace it soon.Read More
Outdoor Gasoline and Electric Powered Equipment and Small Engines
jiangdong snowblower auger belt slips off

C

creteeater_247 on Dec 14, 2008

i have a 5.5 hp jiangdong, snowblower and the auger belt is brand new installed by a small engine repair shop. they said they couldn't find any numbers for it so had to match up the belt by sight. took it in because wanted a tuneup and because the auger belt kept slipping off on me. anyway got it back last week and used the first time three days later and the belt came off again. they want to charge me again but already gave 130.00 bucks anyone have a clue? pulley is tight nothing to me looks abnormal they said they didnt see anything either (the repair shop).Read More

Ask a Question