Pulsa-jet problems

Reply

  #1  
Old 05-03-10, 05:14 PM
Member
Thread Starter
Join Date: Jul 2003
Location: Montevallo, Alabama
Posts: 590
Pulsa-jet problems

I've got a Briggs & Stratton m-130202, t-3129-01, c-90040507, off of a rear tine tiller. It's got a pulsa-jet type carburetor. My question is how do you replace a fuel pick up tube. The brass tube is approximately 2-3/4" long and the fuel pick up tube is 2-1/2" long. According to Briggs you heat it up in hot water and then slip it on. I've even tried heating it up in boiling water and am still not able to get it to slip on. Anyone have other ideas?
 
Sponsored Links
  #2  
Old 05-04-10, 01:51 AM
cheese's Avatar
Forum Topic Moderator
Join Date: Jul 2001
Location: USA
Posts: 16,888
Hmm, I don't recall having too much trouble putting them on, but they are a tight fit. Keep working with it...maybe a heat gun? I just push and twist until it goes on.
 
  #3  
Old 05-17-10, 07:13 AM
Member
Thread Starter
Join Date: Jul 2003
Location: Montevallo, Alabama
Posts: 590
I've got another question, the small clip that holds the fuel pick-up in place. How can you expand the small clip in order to get it over the end of the pick-up tube?
 
  #4  
Old 05-18-10, 01:06 AM
cheese's Avatar
Forum Topic Moderator
Join Date: Jul 2001
Location: USA
Posts: 16,888
It's not intended to be expanded prior to installing, it just expands as you push it on.
 
Reply

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are Off
Pingbacks are Off
Refbacks are Off


Thread Tools
Search this Thread
Display Modes