honda air gap
-
13 replies 167 views
-
8 replies 74 views
-
12 replies 185 views
-
5 replies 86 views
-
6 replies 110 views
-
4 replies 73 views
-
4 replies 57 views
-
4 replies 59 views
-
3 replies 47 views
-
3 replies 76 views
-
Troy Bilt Bronco 2005 (Model#13AJ609G766) Loose Drive Belt
My husband replaced the drive belt on this mower two times with two different belts, one from our local Napa parts store and one from Lowes. The problem is that the belt has too much slack in it. We found the manual online at the Troy Bilt site and we have it threaded the way that is shown, however there is still too much slack and the mower will sometimes go into gear and sometimes not -- this is an automatic transmission machine. He has not put the deck back on yet, but he says that the deck doesn't have anything to do with the drive belt. Just want to see if anyone has any ideas. We're to the point of trying a shorter belt, but the ones we got were replacements for the original. Thanks in advance for any suggestions.Read More
-
New Briggs and Stratton motor on old snapper...ISSUES. PLEASE HELP!
Hello. I recently threw a rod on my old Snapper. I replaced the motor with a new B&S PowerBuilt 17.5 HP engine. After installing, (and filling with oil) I tried to crank it up. In my haste I had forgotten to activate the pressure switch in the seat. It turned over 4 or 5 times, turned slowly, and then wouldn't turn at all. I found out that I had apparently ruined my ignition relay, because if I jumped out the terminals, the starter would attempt to start the engine. I have tried turning the crank manually by twisting the drive plate/shaft with no success. The manual is of no help. Somebody please help me!! -JustinRead More
$Trending
CHECK OUT SIMILAR POSTS
DoItYourself.com®, founded in 1995, is the leading independent home improvement and repair website. We welcome your comments and suggestions. All information is provided "AS IS." Website operating problems contact webmaster@doityourself.com. Questions of a Do It Yourself nature should be submitted to our "DoItYourself.com Community Forums". Copyright© 1995-2023 MH Sub I, LLC dba Internet Brands. All rights reserved. You may freely link to this site, and use it for non-commercial use subject to our terms of use. View our Privacy Policy here.
