DoItYourself.com Community Forums > Cars, SUV's, Vans, Trucks, RV's, Boats and Gasoline Outdoor Power Equipment > Outdoor Gasoline and Electric Powered Equipment and Small Engines

Tecumseh 5hp vertical crank model TVS100 series

Thread Tools

Search this Thread

04-19-12, 07:17 PM

glemond1

Member

Thread Starter

Join Date: Apr 2012

Posts: 1

Upvotes: 0

Received 0 Upvotes on 0 Posts

Tecumseh 5hp vertical crank model TVS100 series

I am having trouble re-assembling the connection between the carb. & the governor on the above engine on a Ariens 911 Series self-propelled 21" mower. There is a plate screwed to the top of carb. that contains the spring with connecting rods to the governor. I can't figure out how this connects to the throttle plate! Should have taken a photo before dis-assembly, ... duh. Does anyone know where I can find a diagram/drawing/photo of the top of the carb.? Thanks

Upvote

04-20-12, 09:19 AM

31YTech

Member

Join Date: Feb 2008

Location: EveryWhere

Posts: 1,093

Upvotes: 0

Received 0 Upvotes on 0 Posts

Hello glemond1,

I believe these pics will help you out....

Good Luck

Upvote

Thread Tools

Search this Thread

Show Printable Version

Email this Page

Outdoor Gasoline and Electric Powered Equipment and Small Engines
Honda Harmony HRR 216 Erratic engine operation

B

bushy on Apr 16, 2012

The engine continually changes RPM, it is as if I were gunning the motor. It goes from a slow idle up to a fast rev and back down. Any ideas?Read More
Outdoor Gasoline and Electric Powered Equipment and Small Engines
19.5 briggs coil problem

D

die106 on Apr 17, 2012

I have a MTD rider that blew a 17.5hp briggs single cyclinder and replaced it with a used 19.5 twin cylinder motor. I ran the motor about 1 1/2 hours and it started missing then died. The coil is definetly bad no spark, my question is was this just bad luck the coil failed or was it compatability from the 17.5 to the 19.5. The only wiring difference was the the 17.5 had a going to the carb fuel bowl and the harness connectors had to e spliced. I also slipped the coil from the 17.5 onto the unit and hooked up to one cylinder and fired off immediatley so I am pretty sure I have the wiring correct.Read More

Ask a Question