This Craftsman mower came to me for repair because it wouldn't move, I do not have a model number on the mower. So I pulled the rear transaxle and took it apart and fount that the shift lever was bad and not shifting collar back onto pump,,,so I thought. The transaxle is a LTH 2000. With that fixed and back into the mower it has reverse now but now forward speed, it does creep forward. My question is this, can the pump be repaired or is it not serviceable, Number on pump is this 7093P1 and that comes from tag on the pump. Peerless -Silent Trac. I just need to know,,,,,,,,,,,,,,,,,,,The mower is a Craftsman and it looks like one of those Murray Pups,,,the seat is over top of the engine,,,,It has a Briggs 13.5 HP engine in it. I may just junk it out and sell the engine for profit. Thanks for your time everyone. Please bare with me on any misspelling.:help:

I have 1999 Generac 10000EXL generator (19hp & 10KW gen) and as I was replacing the battery I inadvertenly connected the battery back wards. Approximately 30-60 seconds after connecting it I noticed a small amount of smoke coming out of the control panel and quickly disconnected the batter. I opened the control panel and found the wires going to the starter switch were burnt so I replaced them, reconnected the battery correctly and started the engine. I left the control panel open so I could confirm the wires did not get hot again and noticed the battery charger rectifier (P/N: 65795) started to smoke and I turned off the generator. I just ordered another rectifier but would like to know if there is anything else I need to look at before I attempt to run this again once I replace the rectifier. The generator is Model# 9801-3. I have attached the owner's manual and pictures of the generator.