I have a Honda gcv 160 on a power washer. I took the carb off to clean it. Unfortunately i didnt pay close attention while removing it and i can not figure out how to re-assemble it to the motor. The main problem is i cannot tell where the air guide goes. If anyone can provide any info. or a good pic (i have check the internet with no luck) i would greatly appreciate it. Thanks

I am not that familiar with electric and perhaps should not be messing with it. However I found that the regulator on my lawn mower is bad. I believe the alternator puts out in ac around 28 volts. I was curious to know if I could actually take a standard ac dc adapter. The square one that you plug in the house. and use that to convert the alternators power from ac to dc. I don't see why not it seems to me that it will work. Obviously I would have to wire up as I cant just plug it into anything. I just figured it sounds logical to me and would help me get rid of one of the extras I have laying around from all the broken electronics i have laying around.