DoItYourself.com Community Forums > Cars, SUV's, Vans, Trucks, RV's, Boats and Gasoline Outdoor Power Equipment > Outdoor Gasoline and Electric Powered Equipment and Small Engines

husqvarna wont start after i tried to get the clutch off .

Thread Tools

Search this Thread

05-17-13, 10:18 AM

russellvito

Member

Thread Starter

Join Date: May 2013

Location: United States

Posts: 2

Upvotes: 0

Received 0 Upvotes on 0 Posts

husqvarna wont start after i tried to get the clutch off .

I took it apart to clean and double check the oil pump . Tried to get the clutch off to no avail. so I gave up and put it together .
Now, it wont start . Whats the deal ?

Upvote

05-17-13, 11:06 AM

geogrubb

Member

Join Date: Jun 2006

Location: United States

Posts: 2,277

Upvotes: 0

Received 28 Upvotes on 27 Posts

What's the equipment? model etc.

Upvote

05-17-13, 08:49 PM

cheese

Forum Topic Moderator

Join Date: Jul 2001

Location: USA

Posts: 15,886

Upvotes: 30

Received 131 Upvotes on 121 Posts

Riding mower, chainsaw, etc...?

Upvote

Thread Tools

Search this Thread

Show Printable Version

Email this Page

Outdoor Gasoline and Electric Powered Equipment and Small Engines
2004 Dixon RAM 50 will not energize starter

R

Rossme62 on May 16, 2013

In a nutshell: Mower started fine, cut several minutes, met neighbor so I turned it off to talk. When I attempted to restart - no go. All I got was the click of the solenoid. Long story shortened up a bit, the battery isn't the culprit, and I have replaced both the starter and solenoid but still get nothing but the 'click' of the solenoid when attempting to start. I have tried shorting the posts on the solenoid, but get nothing - no starter engagement or signs of starter life (I do get plenty of sparks from the battery cable solenoid post to the side of the frame). I guess my question is could the cable from solenoid to starter be bad? It looks fine, I've cleaned the contact ends, etc. Also, I have examined the ground wires from engine to frame and all seems to be nice and tight, etc. In the past, I've had nasty gremlins with all the safety switches, etc. Could those be a player? Is there an engine kill switch wire issue? I'd take it in but I have 3 acres growing and the line at the local shop will put me out of commission for weeks! Any ideas?? Engine is a Briggs and Stratton, 725ELS 25 hp unit.Read More
Outdoor Gasoline and Electric Powered Equipment and Small Engines
Gas won't stop - Nikki Carb on 10HP Generator

B

BallJovi on May 17, 2013

Had an issue not getting gas to the carb on a Coleman 10hp B & S powered generator. Cleaned, new gasket, installed - now I have fuel - more than i need. Gas turned on - and is trickling out of the carb, constantly. Took carb apart again to ensure float and spring were installed properly - Yes, they are, but gas won't stop. Carb is a Nikki. What do I need to do? Any help would be much appreciated. Regards, BJ.Read More

Ask a Question