Removing a serviceable brass seat


  #1  
Old 06-07-13, 06:57 AM
B
Member
Thread Starter
Join Date: Dec 2009
Location: bond county illinois
Posts: 158
Upvotes: 0
Received 0 Upvotes on 0 Posts
Removing a serviceable brass seat

I've never done this before but I would like some advice on the best way to remove a brass seat on a Walbro Carb.I've heard an "easy out" is best. Also tapping with a 1/4 20 thread and them making a homemade puller with a nut an a socket works best.
Any ideas would be appreciated.
 
  #2  
Old 06-07-13, 10:04 AM
cheese's Avatar
Forum Topic Moderator
Join Date: Jul 2001
Location: USA
Posts: 15,834
Received 120 Upvotes on 110 Posts
I've done it with the 1/4" bolt with no problems.
 
  #3  
Old 06-07-13, 10:18 AM
B
Member
Thread Starter
Join Date: Dec 2009
Location: bond county illinois
Posts: 158
Upvotes: 0
Received 0 Upvotes on 0 Posts
removing a seat

Thanx Cheese. Did you have to drill the hole in the seat first or could you just use the tap?
 
  #4  
Old 06-07-13, 10:34 AM
cheese's Avatar
Forum Topic Moderator
Join Date: Jul 2001
Location: USA
Posts: 15,834
Received 120 Upvotes on 110 Posts
I just use a self tapping bolt and screw it directly into the seat, no drilling or tapping.
 
  #5  
Old 06-07-13, 01:10 PM
B
Member
Thread Starter
Join Date: Dec 2009
Location: bond county illinois
Posts: 158
Upvotes: 0
Received 0 Upvotes on 0 Posts
Thanx Cheese for the info.I'll try it that way.
 
  #6  
Old 06-07-13, 02:47 PM
M
Member
Join Date: Oct 2011
Location: USA
Posts: 373
Upvotes: 0
Received 0 Upvotes on 0 Posts
I use a 1/4x20 tap, when it bottoms out the seat will start to turn and then just use a little upward pull as you are turning it and it will come right out. No drilling
 
 

Thread Tools
Search this Thread
 
Ask a Question
Question Title:
Description: