DoItYourself.com Community Forums > Cars, SUV's, Vans, Trucks, RV's, Boats and Gasoline Outdoor Power Equipment > Outdoor Gasoline and Electric Powered Equipment and Small Engines

2005 Toro Personal Pace mechanical rebuild

Thread Tools

Search this Thread

06-20-13, 05:52 AM

brinainlakeelmo

Member

Thread Starter

Join Date: Jul 2007

Location: USA

Posts: 101

Upvotes: 0

Received 0 Upvotes on 0 Posts

2005 Toro Personal Pace mechanical rebuild

I've acquired a 2005 Toro Personal Pace lawn mower that is mechanically a mess. The cables and mechanisms (springs, levers etc.) that operate the carb are twisted, broken, bent or missing.
Could someone please point me to a website where I may able to see schematics or better yet, videos which might show me what is missing and how it should be set up? The mower isn't very old, but the owner could not keep it running and I'd love to put it back together.
Thanks for any help.

Upvote

06-20-13, 07:41 AM

joecaption1

Banned. Rule And/Or Policy Violation

Join Date: Apr 2013

Location: USA

Posts: 3,860

Upvotes: 0

Received 1 Upvote on 1 Post

Tried the Toro web site yet?

Upvote

06-20-13, 12:13 PM

mowerdude

Member

Join Date: Oct 2011

Location: USA

Posts: 373

Upvotes: 0

Received 0 Upvotes on 0 Posts

Like Joe said,,Ditto,,,,,,,,,,,

Upvote

Thread Tools

Search this Thread

Show Printable Version

Email this Page

Outdoor Gasoline and Electric Powered Equipment and Small Engines
Pressure Washer Engine Speed

G

grassnut on Jun 18, 2013

Hi All, I have a North Star (Northern Tool) pressure washer that has a Honda engine and Comet BXD 2530 pump. It's about 4 years old and every time I used it in the past, the engine would idle down (as if under a load) when the the trigger is pressed. One day it stopped idling down and the engine ran at the higher rpm. The pressure is good, just that the engine seems to run at the same speed. When using the detergent nozzle (or no nozzle at all) it does idle down. I decided the problem was the unloader valve so I removed and cleaned the valve but still had the problem. I then ordered a replacement unloader ($89! Ouch) but still the same. One more thing, it goes through gas very quickly. Any ideas or suggestions would be appreciated. Thanks! GrassnutRead More
Outdoor Gasoline and Electric Powered Equipment and Small Engines
craftsman LT 2000 stalled, won't start

P

Peter Case on Jun 20, 2013

I have a Craftsman LT 2000 riding mower, 2011. Wife was mowing the lawn and the mower just shut off. Now it will not start. The starter will turn the engine but the is no attempt to fire. Pulled the plug, has plenty of spark. Holding thumb over plug hole there is compression, and there is gas, Plug is wet and when checking compression hand is covered with gas. Cleaned the air filter. When turning the key the starter turns the engine but still no firing. I make one assumption: if I get spark than all the interlocks are ok. All out of ideas, Help.Read More

Ask a Question