the rip cord
-
13 replies 170 views
-
11 replies 159 views
-
8 replies 109 views
-
10 replies 121 views
-
6 replies 83 views
-
6 replies 83 views
-
5 replies 83 views
-
5 replies 111 views
-
5 replies 89 views
-
16 replies 231 views
-
Continuation of Pressure Washer Problems
wingrider6 on Sep 20, 2013Craftsman Gas Model # 580.752102. Some time back I tried my PW first time of year. It started fine but would instantly quit. Short story--unloader was stuck. Would run and have lots of pressure with trigger pulled, engine stopped immediately when trigger released. After much procrastination I finally ordered a new manifold and unloader (I said unloader was stuck--would not come out of manifold). Put all together today, purged water from hose, engine starts and runs fine but have no pressure. When pulling trigger I get lots of water, but at house pressure, not PW pressure. Am I suppose to adjust unloader or just snug up locking nut (it was loose)? Any thoughts? I did spray some "Pump Defender" in it and am leaving it soak for a while. I never used the defender before--which probably is the heart of my problems.Read More
-
Deere STX38 Throttle Won't Stay at full
I have a Deere STX38 (1996) with a Kohler 13hp. When I throttle up, the throttle handle won't stay at full. It slowly backs down to about 1/2. I constantly have to keep pushing it back up. I checked the springs, cable,etc and everything looks ok. Any help is appreciated.Read More
$Trending
CHECK OUT SIMILAR POSTS
DoItYourself.com®, founded in 1995, is the leading independent home improvement and repair website. We welcome your comments and suggestions. All information is provided "AS IS." Website operating problems contact webmaster@doityourself.com. Questions of a Do It Yourself nature should be submitted to our "DoItYourself.com Community Forums". Copyright© 1995-2023 MH Sub I, LLC dba Internet Brands. All rights reserved. You may freely link to this site, and use it for non-commercial use subject to our terms of use. View our Privacy Policy here.
