Hi All, This is my first post, greetings from Ireland. I have a Husqvarna ride on with a B&S 31G777 0193E1 which won't start. It was working fine when I went to empty the grass collector, turned it off to give the chute a good clean and she wouldn't start again. Cleaned the carb, refreshed the fuel, checked the spark and did a thumb compression test to confirm air blowing out of the spark plug hole. All seems good with all of that. She tries to crank but it just won't catch and start. It's kind of like theres a cut off switch interfering. The only cut off switch is below the seat and it seems to be working ok. Any suggestions or ideas folks, I hate being beaten by this little engine ? Thanks for reading. mh

I have a toro timcutter 42" zero turn that I recently purchased used. It has the 16 HP Briggs and Stratton Engine. It runs great however when the deck is engaged and I'm mowing forward it seems as though I'm losing power. In higher grass sometimes it almost stalls out. When I come back to neutral the RPMS go back to normal. Any advice on this issue? Thanks in advance.