DoItYourself.com Community Forums > Cars, SUV's, Vans, Trucks, RV's, Boats and Gasoline Outdoor Power Equipment > Outdoor Gasoline and Electric Powered Equipment and Small Engines

Briggs & Stratton 11 horse 252707 0638-01 Voltage regulator location

Thread Tools

Search this Thread

07-30-15, 11:07 AM

blcclanman

Member

Thread Starter

Join Date: Jul 2015

Location: USA

Posts: 2

Upvotes: 0

Received 0 Upvotes on 0 Posts

Briggs & Stratton 11 horse 252707 0638-01 Voltage regulator location

Help ! I'm at my wits end trying to find this elusive little bugger. can somebody please tell me where the heck it is ?

I found the Alternator and traced the wiring but I can't seem to find it. any and all help is appreciated !

Upvote

07-30-15, 11:36 AM

Rough Rooster

Member

Join Date: Feb 2014

Location: USA

Posts: 403

Upvotes: 9

Received 16 Upvotes on 12 Posts

Find Replacement & Repair Parts for Briggs & Stratton Engines

Look at picture #501
It is usually mounted on top of starter.

RR

Upvote

07-30-15, 12:32 PM

blcclanman

Member

Thread Starter

Join Date: Jul 2015

Location: USA

Posts: 2

Upvotes: 0

Received 0 Upvotes on 0 Posts

I did thanks however the only thing on top of the starter is a cowl I can see the bendix springs and other parts of the starter but nothing electrical. I have ordered a replacement from amazon for 17.00 and I have traced out the electrical however I have had no success. Any and all help is appreciated !

Upvote

07-30-15, 07:53 PM

cheese

Forum Topic Moderator

Join Date: Jul 2001

Location: USA

Posts: 15,919

Upvotes: 32

Received 133 Upvotes on 122 Posts

Doubtful that it even has one. Most likely it just has a stator and diode.

Upvote

Thread Tools

Search this Thread

Show Printable Version

Email this Page

Outdoor Gasoline and Electric Powered Equipment and Small Engines
Snapper SR930 will not start

W

wainwright on Jul 30, 2015

Hello! I recently purchased two Snapper riding mowers. The one I plan to use and not scrap is the one I will be discussing SR930 model number 300914BE. After unloading it, I jumped it off with my truck and it ran fine. Pto would not engage. I parked it for the night, did some research and was told to bypass the kill switch mounted to the deck by unplugging it from the motor. I did this. I also had to put the belt back on the rear spindle as it had come off while unloading it. Tried to jump it off and it only turns now, wont start up. Checked for spark, its good. I took air filter off, the flap in the carb opens when on full throttle but doesnt close entirely when the choke is applied I poured a little gas in covered the intake for two seconds while cranking it, still nothing. The motor is a Briggs 400 cc 4 cycle. When I try and crank it some times the belt turns, some times not. The blade engage lever is not engaged though. Thanks in advance! Edit: Started immediately and motor ran fine when I initially jumped off. It ran out of gas a minute later, I put more in it started right back up.Read More
Outdoor Gasoline and Electric Powered Equipment and Small Engines
Echo PB-251 leaf blower won't start

D

daronson on Jul 03, 2015

used for 2 seasons. cranks but wouldn't start. replaced spark plug with champion from another blower (owners manual says only use NGK v-groove plug or engine damage can occur). Blower started up, but ran a little sluggish, but worked for the afternoon. next weekend it wouldn't start. replaced plug with OE NGK plug. Still won't start. checked fuel filter, seems like fuel is getting to carb.Read More

Ask a Question