I have a Poulan 2075 chain saw. I replaced the bulb and all the gas lines. Now I can't get it to start. I checked that the lines are correctly connected: the small diameter line has a filter and goes from the gas tank to the top of the carb, the bulb line TANK uses the larger line to the tank, and the bulb line CARB goes to the lower part of the carb. When I pull the plug it is wet and I can see a spark.

I have a John Deere model 828D walk behind snow blower I recently purchased that I believe was manufactured by Ariens about 1996. It seems very well made and has a cast iron gear box for the auger system. I did not get a owners manual with the machine so I'd like to find out what gear oil to use in the augers gear box and what is the proper level. Cast into the side of the gearbox it says "use compound gear oil" followed by L 1, or L2 or LL which is hard to read. Anyone know what this means or what current lubricant I should use and what the proper full level is? Thank you