Go Back

DoItYourself.com Community Forums > Cars, SUV's, Vans, Trucks, RV's, Boats and Gasoline Outdoor Power Equipment > Outdoor Gasoline and Electric Powered Equipment and Small Engines

Reload this Page

>

Husqvarna Mondro grass trimmer

Husqvarna Mondro grass trimmer

Closed Thread

Search this Thread

#1

Old

05-24-16, 09:46 AM

Geochurchi

Geochurchi is offline

Member

Thread Starter

Join Date: Nov 2012

Posts: 5,046

Received 159 Upvotes on 145 Posts

Husqvarna Mondro grass trimmer

Hi All,now that I have the engine running fine the line is depleted,does anyone out there have a owner manual for this unit,I do not have any numbers etc,all I know is it's Mondro, it's got to be old as it is mostly grey in color,I am trying to contact the mfg. but so far no luck.

Upvote

#2

Old

05-24-16, 10:56 AM

Geochurchi

Geochurchi is offline

Member

Thread Starter

Join Date: Nov 2012

Posts: 5,046

Received 159 Upvotes on 145 Posts

Found what I was looking for,I also had it spelled wrong,should be Mondo.

Upvote

Thread Tools

Search this Thread

Show Printable Version

Show Printable Version

Email this Page

Email this Page

Outdoor Gasoline and Electric Powered Equipment and Small Engines
60 Day old Toro w/ B&S engine suddenly hard to pull the recoil starter

K

Keith_W on Jun 19, 2014

In April I purchased a new Toro 30" walk-behind self-propelled mower with a Briggs and Stratton engine (model details below) at Home Depot. There is no throttle or choke control, just a recoil starter rope to get it going and a momentary-contact switch to shut it down. The first 6 or 8 times I used it, it was very easy to start, usually with the first (easy) pull. Suddenly, after no incidents, it became hard to pull the starter. It pulls a bit then hangs up / gets stuck / resists. The point at which the rope becomes hard (often nearly impossible) to pull varies, probably depending on where the piston stroke is at that time. With the plug out it pulls very easily, no hanging up. There's no oil in the cylinder as nothing comes out the plug hole when I pull it with the starter and when I do get it started there's no smoke. Once it's running, it runs perfectly. I'm using SAE 30 oil. It's filled to the full line on the dipstick. I check it each time before mowing. It's remained right on the 'full' mark. I haven't had to add any to it since the initial fill. I found a thread on here where a guy was having the same problem with a pressure-washer. His resolution ended up being that a compression release device had failed and needed to be replaced. I found a parts list on the Briggs and Stratton web site. There is no compression release component. I chatted with a B&S rep who said the compression release is part of the camshaft. The engine model number is 121S02-0130-F1. The engine serial number is 13 11403 62 54352 The Mower is Toro TimeMaster 30in Model 20199 I'm stumped as to what may have cause it. There were no incidents. Just suddenly, it started having this problem. The mower is barely 60 days old. I have at most about 15 to 20 hours on it. Thanks in advance for any help!Read More
Outdoor Gasoline and Electric Powered Equipment and Small Engines
Poulan BVM200VS blower / vac wont start

H

HerContractor on May 24, 2016

I am at my wits end. This is the BVM200VS model. About 9 years old. Just replaced carb, plug, fuel filter, fuel lines, fuel. It will only start on full choke and will run about 10 seconds, then die. I notice when pushing in the fuel primer, it stays in, then very slowly pops out. In order to prime bulb 3x, it takes about 4-5 minutes. Have removed muffler and that is quite clear. I am ready to toss it and buy electric. I have tried putting the old primer bulb on the new carb, and this will pop out quick, but still will not prime properly. I feel that this could be the root of the problem, yet I have no idea why. The fuel filter is new. I have even tried priming without the filter and still it will only run about 5-10 seconds, with no throttle response and only on full choke.Read More

Ask a Question