Simplicity, Kohler control cables
#1
12-10-17, 06:30 AM
Simplicity, Kohler control cables
Too long a story as to why it took so long, but I had to remove an engine on a 1978 Simpliciity landlord that tied up during snow duty last winter. I just got the engine back, and I don't remember how the trottle cable and cable support hooked to the engine after all this time. I should have taken a picture, but didn't, I can figure it out, but since it has a new carb on it now, (part of the problem last year was a throttle plate that was sucked into the engine,) The hook up is escaping me. This engine is a Kohler 241-S same year. Any clues for me in web land? The choke was simple and operating, throttle has a cable, and an L shaped bracket about 2 inches long with a bolt hole in it.
Last edited by WML13; 12-10-17 at 06:31 AM. Reason: spelling
#2
12-10-17, 06:21 PM
Simplicity Kohler Control Cables
After I got it jacked up so I could see it better I could see where the bracket went, and how the throttle was connected. It connects under the carb to the governor control levers, rather than to the carb itself.
