Russian birch ply blotchy lines
#1
Member
Thread Starter
Join Date: Oct 2014
Posts: 155
Received 0 Votes
on
0 Posts
Russian birch ply blotchy lines
Used sanding sealer and two coats of gel stain.
I’ve read lacquer toner can help even things out but can I get these out?
I’ve read lacquer toner can help even things out but can I get these out?
#4
If it was sanded twice I doubt 3x will make a difference. It must be an inferior grade of plywood. Just like any lumber you really have to have an eye for what you are picking out... not every sheet will be of the same quality.
Perhaps those lines are from the ply gluing process. You can only sand veneer so much before you sand right through it. Once you sand through it you're screwed.
Perhaps those lines are from the ply gluing process. You can only sand veneer so much before you sand right through it. Once you sand through it you're screwed.
#6
Well that probably didnt do much more than polish it. So I take back what I said about sanding it a 3rd time. That fine of a grit certainly wont take out any snipe. I would probably have given it a good once over with an orbital and 120, then 150 at the most.
You wont get any of that snipe out unless you sand it with 120, which will probably take off all your sealer and stain. Also sanding sealer is best applied AFTER the stain, unless you are cutting it 50:50 with thinner and your intent is to use it as a wood conditioner to prevent blotching.
You wont get any of that snipe out unless you sand it with 120, which will probably take off all your sealer and stain. Also sanding sealer is best applied AFTER the stain, unless you are cutting it 50:50 with thinner and your intent is to use it as a wood conditioner to prevent blotching.
marksr voted this post useful.