o2 SENSOR

Reply

  #1  
Old 08-07-03, 12:20 PM
AKADA1
Visiting Guest
Posts: n/a
o2 SENSOR

i own an 89 wrangler and was wondering if there is a good resourse to use to change out an o2 sensor? If so which one? Also I am not your local machanic but if there are good directions to repairing or replacing parts i usually manage just fine. Any special tools needed to perform this replacement? Any info would be great. thanks
 
Sponsored Links
  #2  
Old 08-07-03, 12:27 PM
Joe_F
Visiting Guest
Posts: n/a
AZ can sell you or rent you the needed socket (deep socket with a slot in it).

Alternatively, an open end wrench usually works as well.

Just screw the old one out, install the new one. Make sure the exhaust is fairly cold so you don't burn yourself.

Barring that, it's about a 15 minute job, tops.
 
  #3  
Old 08-08-03, 11:22 PM
door-county
Visiting Guest
Posts: n/a
There are tons of forums online for Jeep owners, do a search on google for "Jeep forums." Half the repairs I did on my car were from instructions I followed from forum posts!

...hope that helps.
 
  #4  
Old 08-10-03, 05:52 PM
billys68ss's Avatar
Member
Join Date: May 2003
Location: USA
Posts: 1,459
As long as it is easy to get to a 22mm or 7/8 wrench will work. I like to slip the boxed end of the wrench over the connector (if it will fit) to get good leverage. But since you plan to replace it, you could just cut the wire next the the sensor and whalla. Just dont cut the new one. LOL
Hope this helps,
Billy

P.S. Is there a reason you are replacing it? Just curious.
 
Reply

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are Off
Pingbacks are Off
Refbacks are Off


Thread Tools
Search this Thread
Display Modes