DoItYourself.com Community Forums > Cars, SUV's, Vans, Trucks, RV's, Boats and Gasoline Outdoor Power Equipment > Passenger Cars, Mini Vans, SUV Service and Repairs. (No Trucks)

Door lock switch removal

Thread Tools

Search this Thread

11-28-04, 03:27 AM

messen_d

Visiting Guest

Posts: n/a

Door lock switch removal

I'm trying to remove a rear door panel on a '93 Buick Century wirh electric windows and door locks. How do you remove the door lock switch? I can't remove the panel without removing the chrome door lock switch under the inside door handle. Help

Upvote

11-30-04, 03:15 PM

davo

Member

Join Date: Apr 2002

Location: Pittsburgh,Pa

Posts: 2,400

Upvotes: 0

Received 0 Upvotes on 0 Posts

It just pops off it is just pressed onto a rod inside the door.Play with it a little you'll see what I mean.

Upvote

Thread Tools

Search this Thread

Show Printable Version

Email this Page

Passenger Cars, Mini Vans, SUV Service and Repairs. (No Trucks)
Power Window not working

C

ConfusedGuy on Nov 26, 2004

About a year ago, the driver's window on my 1999 Chrysler Cirrus stopped going up and down. A few months later, it worked for about a week, then stopped working and hasn't worked since. I got a quote at over $250 to replace the window motor, which seems extremely excessive. I have gotten by without the window being able to go down for a while now, but was wondering what my options are (other than spending $250). A buddy told me to take the motor from one of the back windows and put it on the front, but I am unsure if that would work (the driver's side has controls for all four windows) or if it would fit. Any thoughts and/or advise would be greatly appreciated.Read More
Passenger Cars, Mini Vans, SUV Service and Repairs. (No Trucks)
91 2500 gmc no start

N

no5racer on Nov 27, 2004

I have a 91 gmc w/ 350 engine it has spark & fuel , but will not start sometimes it just cranks , but when it does run it will misfire . it has new cap,rotor,wires, spark plugs & ignition module , I was messing with it today I disconnected the the single tan wire for the spark advance on the firewall & the truck starts fine . could this be an ecm problem ?Read More

Ask a Question