Hazed head light - Repairable?
#1
Member
Thread Starter
Join Date: Oct 2004
Location: Florida
Posts: 349
Upvotes: 0
Received 0 Upvotes
on
0 Posts
Hazed head light - Repairable?
Aging and the Floridda sun have made the plastic housing chalked on the surface. I just wonder if anyone has been able to polish it. Thanks.
#3
Member
Thread Starter
Join Date: Oct 2004
Location: Florida
Posts: 349
Upvotes: 0
Received 0 Upvotes
on
0 Posts
Originally Posted by slickshift
What Vehicle?
If it's Lexan, wet sanding with 800 grit, 1500 grit, then buffing (drill mounted buffing wheel) with metal polish (Autosol) will clean them up
If it's Lexan, wet sanding with 800 grit, 1500 grit, then buffing (drill mounted buffing wheel) with metal polish (Autosol) will clean them up
#5
Member
Join Date: Dec 2005
Location: South Florida
Posts: 488
Upvotes: 0
Received 0 Upvotes
on
0 Posts
If those suggestions don't work you get all needed stuff in a kit from these folks:
http://www.lensrenew.com/index.htm
I bought one but haven't done it yet so can't testify to how well it works or how hard it is but supposedly works well.
http://www.lensrenew.com/index.htm
I bought one but haven't done it yet so can't testify to how well it works or how hard it is but supposedly works well.
#6
Member
Join Date: Jun 2002
Location: Quincy, MA
Posts: 127
Upvotes: 0
Received 0 Upvotes
on
0 Posts
lens
I used some polishing compound and a lot of elbow grease
& they came out fine.
Important to follow up with a good anti UV wax, and re-wax on a monthly basis in FL or any sunny place. If they are not protected they'll turn dim again, and that's up here in NE, probably
due to the "soft" plastic they use.
I've also heard of using tooth-paste on a polishing pad attaached to an electric drill. Sounds good, but I haven't tried it
& they came out fine.
Important to follow up with a good anti UV wax, and re-wax on a monthly basis in FL or any sunny place. If they are not protected they'll turn dim again, and that's up here in NE, probably
due to the "soft" plastic they use.
I've also heard of using tooth-paste on a polishing pad attaached to an electric drill. Sounds good, but I haven't tried it
#7
Member
Thread Starter
Join Date: Oct 2004
Location: Florida
Posts: 349
Upvotes: 0
Received 0 Upvotes
on
0 Posts
Thanks. Mine was badly chalked. I started with 600, skipped 1500 because I just didn't have it, finished with polishing compound a sponge wheel on a drill. The plastics came out okay.
I regret I skipped 1500. Had I invested a trip to hardware store, I would have saved time and the final finish would have been better.
Do Not Skip 1500.
Thanks.
I regret I skipped 1500. Had I invested a trip to hardware store, I would have saved time and the final finish would have been better.
Do Not Skip 1500.
Thanks.