DoItYourself.com Community Forums > Cars, SUV's, Vans, Trucks, RV's, Boats and Gasoline Outdoor Power Equipment > Passenger Cars, Mini Vans, SUV Service and Repairs. (No Trucks)

'92 Chevy Cavalier, Steering Column Question

Thread Tools

Search this Thread

04-12-07, 04:57 PM

toastpub

Member

Thread Starter

Join Date: Apr 2007

Posts: 1

Upvotes: 0

Received 0 Upvotes on 0 Posts

'92 Chevy Cavalier, Steering Column Question

I'm replacing a '92 Cavalier steering column and can't get the cable for the shifter to come out of the insert. Is there some sort of special tool required or a process I'm unaware of? I don't want to break anything. Everything else is loose. Please, help.

Upvote

04-12-07, 07:58 PM

geogrubb

Member

Join Date: Jun 2006

Location: United States

Posts: 2,276

Upvotes: 0

Received 28 Upvotes on 27 Posts

Got to autozone.com, select repair info, then enter your auto stuff, maybe they have the info you need. Have a good one. Geo

Upvote

Thread Tools

Search this Thread

Show Printable Version

Email this Page

Passenger Cars, Mini Vans, SUV Service and Repairs. (No Trucks)
99 Regal Hesitating

S

stickshift on Apr 12, 2007

Above 40 mph, light acceleration or holding speed on a small hill causes a shuddering of the car and the tach jumps up and down over a range of about 200 rpm. If you stepped harder on the gas and made it down shift, everything was fine. Plugs, wires and fuel filter were replaced, no effect. Check engine light came on, code came back EGR - replaced, no effect. Check engine light came on again, said transmission clutch (or something like that), leaking battery was replaced, no effect. Problem's gotten a little worse in the last week, now misbehaving at pretty much all speeds, even when accelerating hard enough to get a down shift. Any guesses?Read More
Passenger Cars, Mini Vans, SUV Service and Repairs. (No Trucks)
83 Toyota Diesel - starter bench tested & ok, next?

C

clunk on Mar 24, 2007

Greetings, My 83 Diesel FJ47 troop carrier, 2H motor, is not starting. *motor turns over (using pipe wrench). *starter motor bench tested and worked, although it was oily inside. The noise when the ignition key is turned is a definately clunk, not a click click. A couple of times before this problem (of not starting at all) the starter motor did not engage - about once or twice in a year, but it then worked again. The battery is charged. Any help would be appreciated as to what i can do next. Thanks.Read More

Ask a Question