DoItYourself.com Community Forums > Cars, SUV's, Vans, Trucks, RV's, Boats and Gasoline Outdoor Power Equipment > Passenger Cars, Mini Vans, SUV Service and Repairs. (No Trucks)

Plymouth Grand Voyager Drive Belt Tensioner

Thread Tools

Search this Thread

10-21-07, 03:19 PM

shawnolson

Member

Thread Starter

Join Date: Oct 2007

Posts: 1

Upvotes: 0

Received 0 Upvotes on 0 Posts

Plymouth Grand Voyager Drive Belt Tensioner

I am needing to replace the Accessory Drive Belt Tensioner on a 99 Plymouth Grand Voyager 3.3L and am having trouble removing the old one. Any suggestions would be greatly appreciated.

Upvote

10-21-07, 04:28 PM

bejay

Member

Join Date: Dec 2001

Posts: 2,489

Upvotes: 0

Received 0 Upvotes on 0 Posts

its not to bad to get to uderneath the van just remove the tensioner nut and slide out the old one and install the new one and reinstall belt just support the van on jackstands or ramps so you can get under the van.

Upvote

Thread Tools

Search this Thread

Show Printable Version

Email this Page

Passenger Cars, Mini Vans, SUV Service and Repairs. (No Trucks)
how to remove cv driver side axle for 96 kia?

S

signtech909 on Oct 20, 2007

no matter what i've done the darn thing won't come out.. is there something special that i need to do to get the axle out of the tranny? i've banged on it, used a pry bar, removed other side axle to bang it from the opposite side put there is something in the way so i could'nt do that. any suggestions would greatly be appreciated.... it seems like the little ring may be stopping it from comeing out but there is no way to getto it....is there? thanks
Passenger Cars, Mini Vans, SUV Service and Repairs. (No Trucks)
99 Intrepid heater fan resistor burns out

F

frankiee on Oct 21, 2007

I replaced the resistor block" in my 1999 Chrysler Intrepid and 4 days later it burnt out again. When they burn out, only high speed for the fan works. The 3 speeds below that dont work. I put in a new one when I put one in and the parts guy new exactly what I was talking about. My question is: [B][I][U]Are these cars hard on them resistors or is there a problem in my electrical system [/U][/I][/B]that is going to burn these out. Each one cost $40 Should I ask the parts guy if I can get another one free because the other one only lasted 4 days? Thanks

Ask a Question