DoItYourself.com Community Forums > Cars, SUV's, Vans, Trucks, RV's, Boats and Gasoline Outdoor Power Equipment > Passenger Cars, Mini Vans, SUV Service and Repairs. (No Trucks)

A/C for 92 Jaguar xj6

Thread Tools

Search this Thread

08-19-08, 08:38 PM

jault01

Member

Thread Starter

Join Date: Jul 2008

Posts: 7

Upvotes: 0

Received 0 Upvotes on 0 Posts

A/C for 92 Jaguar xj6

I have no A/C at the moment in my 92 Jaguar xj6. Can anyone tell me where the sight glass is to check the refrigerant out? I can not find a location on AllData.

Thanks

Upvote

08-20-08, 02:52 AM

Littlemike69

Member

Join Date: Jun 2008

Posts: 7

Upvotes: 0

Received 0 Upvotes on 0 Posts

Most likely you won't have a sight glass on the vehicle. To get an idea of the state of charge you will need a set of gauges.

Upvote

Thread Tools

Search this Thread

Show Printable Version

Email this Page

Passenger Cars, Mini Vans, SUV Service and Repairs. (No Trucks)
1989 Chev Astro van Electric Window Problem

L

LarryDHays on Aug 18, 2008

I have a Chev 98 Astro Van and the driver's side window will only go up aways and then it will stop for a few minutes and then it will go againup or down. When I help by lifting the glass then it will go all the way.I beleive the window motor has a thermo fuse or thermal Breaker, but I don't have a Electrical Schematic only a owners manual. can you direct me to the location and advise what I'm looking for? [email]Larry@actionem.com[/email] :coffee:
Passenger Cars, Mini Vans, SUV Service and Repairs. (No Trucks)
Remove Front Disc Brake Rotor of 1990 Honda Accord

D

diyman on Jun 23, 2007

1990 Honda Accord LX, 4 doors, AT, 177,000 miles. I want to change front disc brake rotor and following steps in Autozone.com (see link http://www.autozone.com/az/cds/en_us/0900823d/80/0d/1c/42/0900823d800d1c42/repairInfoPages.htm). After removing 4 bolts retaining the hub unit to the steering knuckle, I can't remove hub unit (4th picture or 1st picture under 1990-95 Accord section). I still have hub unit and steering knuckle hangging. Do I have to take it off? Is there a trick or special tool I need to seperate hub unit and steering knuckle? Any place will take this job and how much will it cost? Any comments and suggestions are appreciated! Thanks in advance!!

Do Not Sell or Share My Personal Information

Cookie Settings

DoItYourself.com®, founded in 1995, is the leading independent home improvement and repair website. We welcome your comments and suggestions. All information is provided "AS IS." Website operating problems contact webmaster@doityourself.com. Questions of a Do It Yourself nature should be submitted to our "DoItYourself.com Community Forums". Copyright© 1995-2023 MH Sub I, LLC dba Internet Brands. All rights reserved. You may freely link to this site, and use it for non-commercial use subject to our terms of use. View our Privacy Policy here.

Ask a Question