DoItYourself.com Community Forums > Cars, SUV's, Vans, Trucks, RV's, Boats and Gasoline Outdoor Power Equipment > Passenger Cars, Mini Vans, SUV Service and Repairs. (No Trucks)

change oil message on 2000 chevy venture

Thread Tools

Search this Thread

09-12-08, 06:23 AM

reyes45

Member

Thread Starter

Join Date: Mar 2003

Location: Michigan, USA

Posts: 70

Upvotes: 0

Received 0 Upvotes on 0 Posts

change oil message on 2000 chevy venture

I recently did an oil change on my 2000 chevy venture but I don`t know how to reset the oil life monitor. I don`t have the owners manual to check.

Upvote

09-12-08, 09:37 AM

goldstar

Member

Join Date: Oct 2002

Location: Hamilton County, Ohio

Posts: 3,927

Upvotes: 0

Received 2 Upvotes on 2 Posts

With the ignition key in the run position but with the engine off, press the gas pedal to the floor and slowly release - three times in five seconds. Turn the ignition off. It should be re set.

Check the link below for an online service manual for the 2000 Venture.

http://safemanuals.com/user-guide-in...VENTURE%202000

Upvote

09-13-08, 08:54 AM

reyes45

Member

Thread Starter

Join Date: Mar 2003

Location: Michigan, USA

Posts: 70

Upvotes: 0

Received 0 Upvotes on 0 Posts

Thans for the info, And thanks for the link.

Upvote

Thread Tools

Search this Thread

Show Printable Version

Email this Page

Passenger Cars, Mini Vans, SUV Service and Repairs. (No Trucks)
Loose Steering on 1979 Camaro

J

jdawg on Sep 12, 2008

I have a 79 camaro and the steering feels very loose on the highway. I checked the outer tie rod ends and the left side has a noticeable amount of verticle movement. Would that be the sole cause of the looseness? How do I check the inner tie rod ends, centerlink, and idler arm for wear? What are the chances that and inner tie rod, center link, or idler arm is causing this problem? Thanks, Jon
Passenger Cars, Mini Vans, SUV Service and Repairs. (No Trucks)
68 Mustang AC problems

R

rbthom on Sep 12, 2008

My dad's 68 mustang's ac compressor stays on no matter where you set the temperature or the vent setting. Like, if the heater is set to on, it still cycles. Does anyone have a wiring schematic or an answer to this? Thanks, Brian

Do Not Sell or Share My Personal Information

Cookie Settings

DoItYourself.com®, founded in 1995, is the leading independent home improvement and repair website. We welcome your comments and suggestions. All information is provided "AS IS." Website operating problems contact webmaster@doityourself.com. Questions of a Do It Yourself nature should be submitted to our "DoItYourself.com Community Forums". Copyright© 1995-2023 MH Sub I, LLC dba Internet Brands. All rights reserved. You may freely link to this site, and use it for non-commercial use subject to our terms of use. View our Privacy Policy here.

Ask a Question