Equivalent sheetrock screw to nail sizes

Reply

  #1  
Old 12-20-18, 02:51 PM
M
Member
Thread Starter
Join Date: Mar 2009
Location: Northern Virginia
Posts: 3,994
Received 2 Votes on 2 Posts
Equivalent sheetrock screw to nail sizes

Code states what type of nails should be used for 1/2" and 5/8" drywall, but only says "or equivalent drywall screws". What exactly does "equivalent" refer to? The length? Reason I ask is because I have a huge box of 1-5/8" screws that I'd like to use for the 5/8" drywall ceilings (adhesive will be used) and another large box of 1-1/4" screws that I'd like to use for the 1/2" walls.
 
Sponsored Links
  #2  
Old 12-20-18, 03:10 PM
M
Forum Topic Moderator
Join Date: Mar 2005
Location: USA - N.E.Tn
Posts: 47,702
Received 330 Votes on 293 Posts
I almost always use 1 5/8" screws although I rarely hang 5/8" board. The only times I've ever used 1 1/4" screws is with 3/8" drywall or with steel studs [different screw thread] I don't know what the code requirements are.
 
  #3  
Old 12-20-18, 03:44 PM
A
Member
Join Date: Jan 2013
Location: U.S.A.
Posts: 2,083
Received 67 Votes on 61 Posts
Sounds like you're on the right track. Like Mark, I'm not exactly sure of code requirements for screw length, except that I do know that the minimum setback for routing NM cable through a stud is 1-1/4", so to avoid inadvertently running a screw into existing cables, assuming they were installed to code, you would want a maximum 1-1/4" in the stud. And knowing that things are not perfectly centered in the real world I would err to something closer to 1" penetration.
 
  #4  
Old 12-20-18, 09:43 PM
czizzi's Avatar
Member
Join Date: Jul 2007
Location: USA
Posts: 7,388
Received 14 Votes on 12 Posts
I use almost exclusively 1 1/4" screws, although like Marksr I don't hang a lot of 5/8" material. I also use 1" screws if the drywall is to go up on furring strips nailed to a block wall. You are probably clear of any electrical on the ceiling joists, however make good notes as to where electrical is fished through the studs or install nailing plates before hanging your drywall.
 
  #5  
Old 12-21-18, 04:12 AM
B
Member
Join Date: Oct 2001
Location: USA
Posts: 964
Received 3 Votes on 3 Posts
I have a very old (20+ years) USG installation guide that I used for years before I retired. It calls for 1-1/4" screws for 1/2" drywall and 1-5/8" screws for 5/8" drywall. I don't know if code required it, but I always installed nailing strips where electrical wiring ran through walls.
 
Reply
Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are Off
Pingbacks are Off
Refbacks are Off


Thread Tools
Search this Thread
 
Ask a Question
Question Title:
Description:
Your question will be posted in: