keyless entry programming 2004 Dodge Ram 1500

Reply

  #1  
Old 04-30-08, 02:01 PM
Member
Thread Starter
Join Date: Apr 2008
Location: Missouri
Posts: 6
keyless entry programming 2004 Dodge Ram 1500

How do I reprogram the keyless entry?
 
Sponsored Links
  #2  
Old 04-30-08, 06:02 PM
Member
Join Date: Feb 2008
Location: Michigan
Posts: 977
Do you still have your owners manual ?
You probably need the original code-
Call the dealer???????
 
  #3  
Old 05-01-08, 01:32 PM
Member
Join Date: Oct 2004
Location: Ontario
Posts: 539
good luck

New Remote Keyless Entry (RKE) transmitters can be programed using the DRB III scan tool and the proper Diagnostic Procedures manual. The DRB III scan tool can provide confirmation that the PCI data bus is functional, and that all of the electronic modules are sending and receiving the proper messages on the PCI data bus.

The following procedure can be used as long as one programmed transmitter is available:

NOTE: When entering program mode using that programmed fob, ALL currently programmed fobs will be erased and they will have to be reprogrammed for the vehicle. If program mode is entered and no action is performed, the previously programmed fobs will continue to function.



Enter the vehicle and close all doors.
Fasten the seat belt (this will cancel the seat belt chime). Turn the ignition to the ON position.
Press and hold the UNLOCK button on a programmed transmitter for 4 seconds . Within 6 seconds with the UNLOCK button still depressed, press the PANIC button. When a single chime is heard, release both buttons. The chime indicates the system is in program mode.
Press and release both the LOCK and UNLOCK buttons simultaneously on a fob to be programmed. A single chime will be heard, this indicates the fob has been recognized.
Within 4 seconds of hearing the chime, press and release the LOCK or UNLOCK button on the fob being programmed A single chime will be heard, this indicates the fob has been programmed.
Repeat steps 4 and 5 for up to a total of 4 fobs.
Turn the ignition OFF.
Cycle the ignition or wait 60 seconds . The vehicle will remain in program mode for up to 60 seconds from when the original chime (step 3) was heard. After 60 seconds , all programmed transmitters will function normally.
 
  #4  
Old 05-01-08, 03:02 PM
Member
Join Date: Feb 2008
Location: Michigan
Posts: 977
Originally Posted by mplaster View Post
How do I reprogram the keyless entry?
Are you talking about the remote entry transmitter (the one with your keys ) or the keyless entry system ( the buttons mounted by or on your car door)????
 
  #5  
Old 05-01-08, 04:09 PM
Member
Thread Starter
Join Date: Apr 2008
Location: Missouri
Posts: 6
keyless entry programming

the one with keys/remote
 
  #6  
Old 05-01-08, 04:56 PM
Member
Join Date: Feb 2008
Location: Michigan
Posts: 977
Originally Posted by mplaster View Post
the one with keys/remote
If you still have it--all that info is in your owners manual
RTFM
 
Reply

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are Off
Pingbacks are Off
Refbacks are Off


Thread Tools
Search this Thread
Display Modes
'