Hi all, Happy New Year! I started off the year with alittle leakage problem and looking for some help. It seems one of the baseboard valve started leaking on the second level and caused a bit of damage already. Not sure if this requires a plumber or is it a quick fix with a screwdriver. Could anyone give me a pointer? [img]https://cimg9.ibsrv.net/gimg/www.doityourselft.com-vbulletin/1372x1483/2023_01_01_0fa97ece9510bed85d271c0da1fc38bdcc8252e6.png[/img] Tried redirecting the water but its a bit more than the thread can handle. Thanks,

I am building a laundry sink/cabinet in my basement and the outlet pipe is above the level of the sink, so I need to install a pump under a 2-basin stainless steel sink. I am trying to lay out the plumbing, but I am unable to find these depths in order to (roughly) calculate the pipe lengths, and whether or not I will have enough room under the sink for all of the fittings. Maybe needing to increase the height of the counter... I can't seem to find charts online that specify the intrusion depth of the pipe into the fitting, or male thread into female NPT. I need: 1. Intrusion of 1-1/2" Schedule 40 PVC pipe into solvent fitting (some places say the depth of the hub = pipe thickness, other places say the pipe only sits 2/3 of the way into the fitting, not bottoming out). 2. Intrusion of 1-1/2" schedule 40 PVC male NPT into female NPT. 3. Intrusion of 1-1/4" schedule 40 PVC into solvent fitting 4. Intrusion of 1-1/4" schedule 40 PVC male NPT into female NPT. I've read that there can be some variation in manufacturers, but was wondering if anyone has any rough average lengths? Thanks, --Sean