Pool pulling apart

Reply

  #1  
Old 06-25-05, 05:05 AM
Johnniebp
Visiting Guest
Posts: n/a
Pool pulling apart

After removing rails to change pool light , screws were left out for two days. There is now a gap and screws cannot be reinserted. Does anyone know what is used and how to pull back together without draining pool. This is above ground pool.
 
Sponsored Links
  #2  
Old 06-26-05, 04:04 PM
Member
Join Date: Dec 2004
Location: So. Calif.
Posts: 540
providing the light niche is just backed away, take a screw to your local hardware store and buy all thread rod, they are probably 1/4" course but you will have to determine correct size, thread, screw two into ajacent sides of the light pull the niche, [ shell ] towards you enough to get a screw of the proper length started , dont tighten all the way do the same on the other side, then install all the other screws , tighten in a cross patch manner to apply equal pressure on the unit. don't overtighten the screws whatever you do.

add silicone seal to the parts before installing to make a water tight seal, wait 24 hours for the silicone to cure before adding water.

steve
 
Reply

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are Off
Pingbacks are Off
Refbacks are Off


Thread Tools
Search this Thread
Display Modes
'