Search: Posts Made By: arlp
Showing results 1 to 25 of 57
Search took 0.01 seconds.
Replies: 2
Views: 1,272
Posted By arlp

sounds liketiming is off.Make sure timing marks...

sounds liketiming is off.Make sure timing marks are lined up.



AutoZone.com | Vehicle Selection - Year...
Replies: 4
Views: 1,828
Posted By arlp

1997 F150 misfire

1997 F150 5.4L Triton V8 automatic.When driving with the rpm's between 2000-3000 engine seems to misfire.If I step on gas or let off it goes away.Can any one help? Thankyou.
Replies: 3
Views: 945
Posted By arlp

Thankyou. In the manuel it says to line up paint...

Thankyou. In the manuel it says to line up paint mark on shaft.I do not see a paint mark.
Replies: 3
Views: 945
Posted By arlp

1998 Gmc K2500 P/u 5.7l

How do I replace distributor? When I put it to TDC where should rotor be pointing? Thankyou.
Replies: 1
Views: 1,175
Posted By arlp

Refrigerator wont't cool

My Refrigerator only cools to 45 degrees.The freezer on top works fine.It is a Kenmore Refrigerator.Can you help me?Thank you.
Replies: 1
Views: 965
Posted By arlp

Try this link. ...

Try this link.
http://www.autozone.com/servlet/UiBroker?ForwardPage=/az/cds/en_us/0900823d/80/13/cd/89/0900823d8013cd89.jsp
Replies: 5
Views: 1,474
Posted By arlp

Extended cranking time 96 dodge intrepid

i have a 96 dodge intrepid with the 3.5 and the cranking time befor it starts is long but its longer when the car is cold if anyone has any ideas i would appreciat it if u could help me
Replies: 4
Views: 1,507
Posted By arlp

snapped bolt

1988 Dodge Dakota 3.9L.Thermostat housing was leaking.I snapped one of the bolts off.There is plenty of room to drill it out but can't find a bit that will drill it.What kind of bit should I use?
Replies: 2
Views: 1,451
Posted By arlp

What are you working on? Are the rear brakes disc...

What are you working on? Are the rear brakes disc or drum brakes?
Replies: 4
Views: 1,401
Posted By arlp

Thankyou, that is what I needed to...

Thankyou, that is what I needed to know.GTO,Lemans, and Firebird came with 455.
Replies: 4
Views: 1,401
Posted By arlp

I was told to set at 12* before TDC.Does anyone...

I was told to set at 12* before TDC.Does anyone know at what RPM?
Replies: 4
Views: 1,401
Posted By arlp

1971 Pontiac Le' Mans 455 cu. in. engine

Does anyone know what the timing should be set at?Thank you.
Replies: 12
Views: 6,674
Posted By arlp

Had this problem on same car.Pieces broke off the...

Had this problem on same car.Pieces broke off the # 4 cylinder valve and but hole in piston. Check compression.
Replies: 3
Views: 1,639
Posted By arlp

My mantis did same thing.I rebuilt carb and had...

My mantis did same thing.I rebuilt carb and had same problem.In the exhaust there is a screen that was plugged up.Had it sand blasted and it ran fine.Don't know if you need this screen or not as it...
Replies: 2
Views: 1,431
Posted By arlp

air bag warning light

1998 Hyundai Elantra 1.8L automatic.The airbag warning light came on.Does anyone know what could cause this?
Replies: 2
Views: 1,334
Posted By arlp

I don't think it is in the motor.There is no...

I don't think it is in the motor.There is no power getting to it at the right time.The relays check out all right.Looking at wiring diagram there is part called Generic Electronic Module [GEM].I was...
Replies: 2
Views: 1,334
Posted By arlp

wiper problem

1996 Ford Explorer 6cyl 4.0L The wipers won't work with truck running.With motor off and key in run position wiper in fast postion wipers will run like they should in intermitent postion.Any other...
Replies: 7
Views: 12,776
Posted By arlp

I use the bath tub when wife isn't looking.

I use the bath tub when wife isn't looking.
Replies: 9
Views: 4,754
Posted By arlp

If the parking brake cable is not working on both...

If the parking brake cable is not working on both sides it needs to be replaced. This could be problem.
Replies: 9
Views: 4,754
Posted By arlp

Is the adjuster in backwards? I think if it is...

Is the adjuster in backwards? I think if it is reversed it will tighten going forward.Does it happen on both sides?
Replies: 4
Views: 1,920
Posted By arlp

REMOVAL & INSTALLATION The hazard warning...

REMOVAL & INSTALLATION

The hazard warning flasher is located on the rear side of the fuse panel.

Locate the hazard flasher in the fuse panel.

Pull the flasher out. DO NOT TWIST.

To...
Replies: 4
Views: 1,920
Posted By arlp

The flasher should be around the fuse box or...

The flasher should be around the fuse box or around the steering colum.Turn directional on.The noise you hear is the flasher for the turn signal.Locate it and then look for another one.This should be...
Replies: 9
Views: 2,210
Posted By arlp

If head being warped wasn't the problem I don't...

If head being warped wasn't the problem I don't know how the coolant got into the oil.The head gasket looked okay.
Replies: 4
Views: 1,920
Posted By arlp

Sounds like the fiasher for the hazard lights is...

Sounds like the fiasher for the hazard lights is blown.DO the hazard lights come on any time? If not it is the flasher.
Replies: 9
Views: 2,210
Posted By arlp

Going to take it to machine shop today. Checked...

Going to take it to machine shop today. Checked it again and a .003 gauge fits under.Could be straight edge is off.
Showing results 1 to 25 of 57
 


 
Forum Jump