Search: Posts Made By: rkt88403
Showing results 1 to 10 of 10
Search took 0.01 seconds.
Replies: 13
Views: 4,526
Posted By rkt88403

Angry Got it back together except for the shroud. Good...

Got it back together except for the shroud. Good spark at plug. Tried starting it and lost spark. Paid $100 for it and sunk another $70 in parts. I parked outside. Let the thing get buried in the 6"...
Replies: 13
Views: 4,526
Posted By rkt88403

I went out and pulled the flywheel again....

I went out and pulled the flywheel again. Checking everything over again. When I picked up the flywheel to re-install it,I noticed that one of the magnets were loose. It was held in position by the...
Replies: 13
Views: 4,526
Posted By rkt88403

New coil. No go. Ended up with a very weak spark....

New coil. No go. Ended up with a very weak spark. Pulled the flywheel to double check connections. Now no spark. :wall: :wall: :wall:
Replies: 13
Views: 4,526
Posted By rkt88403

I did replace the spark plug,along with points...

I did replace the spark plug,along with points and condenser. Disconnected the shut down ground wires,and still no spark.
Replies: 13
Views: 4,526
Posted By rkt88403

Replaced plug,points,and condenser. Still no...

Replaced plug,points,and condenser. Still no spark. Magnets are strong. All wires seem to be fine? Coil?
Before this thing died I had to run it on almost full choke. It seemed to want to only run...
Replies: 13
Views: 4,526
Posted By rkt88403

Thanks Aziz, I went to the Sears parts store...

Thanks Aziz,
I went to the Sears parts store today and bought the plug,points,and condenser. I also ordered a new recoil assembly.
I hope to get back to it tomorrow.
Replies: 13
Views: 4,526
Posted By rkt88403

Thanks Cheese. How would I check the condenser?

Thanks Cheese. How would I check the condenser?
Replies: 13
Views: 4,526
Posted By rkt88403

Question Craftsman Snowblower.

Hi All,
I recently bought an old craftsman 22" snowblower. Model 536 909440. Another number on the plate 8292. It has a tecumseh motor,craftsman #143-687022,ser# 8193B. I have a tecumseh mechanics...
Replies: 10
Views: 10,305
Posted By rkt88403

I just replaced the fuel hose on my tecumseh...

I just replaced the fuel hose on my tecumseh powered snowblower. It is 1/4". Primer hose I tried was 3/16. Good fit to the carb,but too big for the primer bulb. Ended up using some old auto...
Replies: 2
Views: 1,571
Posted By rkt88403

If this is a 4 stroke,check the oil level. If the...

If this is a 4 stroke,check the oil level. If the float stuck,the crankcase might be full of gas.
Showing results 1 to 10 of 10


 
Forum Jump