Search: Posts Made By: dd7
Showing results 1 to 12 of 12
Search took 0.01 seconds.
Replies: 3
Views: 1,412
Posted By dd7

thanks, BB...but

we are going to stack the washer/dryer. Should I put a rubber pad under each of the feet of the washer? Will this help isolate the vibration?
Dave :gmorning:
Replies: 3
Views: 1,412
Posted By dd7

Need install tips - Kenmore HE4t washer

As part of a kitchen remodel we created a 1st floor laundry room. We put down a floating cork floor. I am now reading that my HE4t washer should not be installed over a floating floor due to the...
Replies: 2
Views: 8,088
Posted By dd7

Thanks Pecos

I think I will press for the replacement of each 8 x 8 section that has been broken. As for who will pay for it, the owner has contacted me and said that the driver felt terrible and that he "wants...
Replies: 2
Views: 8,088
Posted By dd7

Broken driveway - repair or replace

Hello - Long story short, my driveway was poured about 6 years ago. Expansion joints were cut or placed about every 8 feet. A week ago a heavy truck drove along the edge of my driveway causing the...
Replies: 3
Views: 2,029
Posted By dd7

Thanks

I wasn't quite sure where to put it.
Replies: 3
Views: 2,029
Posted By dd7

Is installing a central vac a DIY project?

I am think of buying a central vac system for the first floor of our house. The first floor is all hardwood and cork, which would be very easy to keep clean with a central system. Just curious of...
Replies: 4
Views: 2,553
Posted By dd7

Cabinets: Plywood vs. Particle Board?

Man, I am getting a lot of conflicting advice concerning the construction of kitchen cabinets. I understand that all-wood (plywood and solid) is probably the very best option. But if I want to save...
Replies: 3
Views: 1,573
Posted By dd7

Thumbs up Follow-up

Well, I took the car to the dealer. They told me that the problem was loose valve stem seals?, and they replaced them all. I sure did not think it was oil burning, but the problem is gone. They...
Replies: 3
Views: 1,573
Posted By dd7

smoky start-up exhaust

I own a 2002 Saturn L300. It is driven primarily to work and back (5 miles total), but it is also the car that goes on road trips. When I start it, a cloud -sometimes small, sometimes large- of...
Replies: 3
Views: 1,056
Posted By dd7

Thanks! We were surprised that the flaw was not...

Thanks! We were surprised that the flaw was not noticed when being rolled out, and are more inclined to think that it was noticed and ignored.

I think we are going to accept his proposal and just...
Replies: 3
Views: 1,056
Posted By dd7

Tear-off low-slope? New decking over old?

Hello,
I recently had a low-pitch roof of a family room addition replaced. The roofer replaced some of the decking and applied roll roofing. After completion (and after we paid him) I inspected...
03-14-05, 09:24 AM
Replies: 1
Views: 1,051
Posted By dd7

Six layers of paint! and I screwed up...

I am in the process of preparing my dining room walls to be painted. There was a small patch of peeling paint that needed to be removed. I got carried away and now have a very large butterfly...
Showing results 1 to 12 of 12


 
Forum Jump