Search: Posts Made By: Wirepuller38
Showing results 1 to 25 of 200
Search took 0.01 seconds.
Replies: 8
Views: 210
Posted By Wirepuller38

I put mine in my bench vise. The hub is long...

I put mine in my bench vise. The hub is long enough to catch in the vise. Then use two large flat bit screwdrivers. Ratchet strap around the new tire to push the tire bead to the rim. Good luck with...
02-20-24, 07:41 AM
Replies: 5
Views: 221
Posted By Wirepuller38

Install a downspout at the end where the water is...

Install a downspout at the end where the water is accumulating.
Replies: 9
Views: 316
Posted By Wirepuller38

Check the speakers to see if any of them have a...

Check the speakers to see if any of them have a volume knob. If so, turn the knob to see if that helps.
01-29-24, 06:41 AM
Replies: 12
Views: 287
Posted By Wirepuller38

Can you post a photo of the latch you are now...

Can you post a photo of the latch you are now using?
Replies: 3
Views: 154
Posted By Wirepuller38

Would removing and re-installing the circuit fuse...

Would removing and re-installing the circuit fuse be of any benefit? Sort of like a re-boot?
Replies: 14
Views: 377
Posted By Wirepuller38

The data in your thread appears to be formatted...

The data in your thread appears to be formatted as text. Look at the first character in the dates.
Replies: 3
Views: 154
Posted By Wirepuller38

Non-Responsive Touch Screen - 2015 Colorado Pickup

I have a non-responsive touch screen on this truck. The problem in intermitten. What are your suggestions to correct?
12-26-23, 07:25 AM
Replies: 3
Views: 299
Posted By Wirepuller38

What size wire are your underground feeders?

What size wire are your underground feeders?
Replies: 7
Views: 218
Posted By Wirepuller38

Replaced the piston bumper. After a few stops and...

Replaced the piston bumper. After a few stops and starts in assembly, it is now re-assembled and working. Thanks for you guys help.
12-10-23, 06:59 AM
Replies: 4
Views: 255
Posted By Wirepuller38

And what is your question?

And what is your question?
Replies: 7
Views: 218
Posted By Wirepuller38

I opened the top end and found a mangled piston...

I opened the top end and found a mangled piston bumper. I have a replacement on order.
Replies: 7
Views: 218
Posted By Wirepuller38

Thank you, Dane. I will give it a shot.

Thank you, Dane. I will give it a shot.
Replies: 7
Views: 218
Posted By Wirepuller38

Nailer Hung Up

My Porter Cable FN250A 16 gauge finish nailer driver pin does not fully retract.

I have lubricated with no success.
...
11-30-23, 07:46 AM
Replies: 16
Views: 389
Posted By Wirepuller38

All wire connections must be accessable.

All wire connections must be accessable.
11-01-23, 05:59 AM
Replies: 9
Views: 321
Posted By Wirepuller38

Roofing felt nails.

Roofing felt nails.
10-25-23, 01:33 PM
Replies: 5
Views: 197
Posted By Wirepuller38

What size run are we talking about? Are there...

What size run are we talking about?
Are there predators to be concerned about?
Replies: 6
Views: 667
Posted By Wirepuller38

I had this same issue on my Ryobi string trimmer....

I had this same issue on my Ryobi string trimmer. The fix was to tighten all four carb screws holding the carb together. Loose screws were letting in too much air. Hope this helps.
10-13-23, 06:40 AM
Replies: 7
Views: 214
Posted By Wirepuller38

Install a valve in the closest heated area. Close...

Install a valve in the closest heated area. Close the valve during freezing temperatures and drain the line to prevent pipe damage.
If a water hose is connected to the spigot, remove the hose to...
10-13-23, 06:29 AM
Replies: 2
Views: 192
Posted By Wirepuller38

A hole saw will not drill a hole in a post. ...

A hole saw will not drill a hole in a post.


How are the posts secured in the ground? Tamped dirt or concrete?
Replies: 5
Views: 273
Posted By Wirepuller38

Check to be sure it is not full time 4-wheel...

Check to be sure it is not full time 4-wheel drive.
Replies: 2
Views: 192
Posted By Wirepuller38

Thanks for the reply. Before I saw your reply, I...

Thanks for the reply. Before I saw your reply, I used the doubled thickness of an index card and it worked great. Thanks for the help.
Replies: 2
Views: 192
Posted By Wirepuller38

Ryobi RY253SS String Trimmer

When installing ignition module, what is the proper clearance between the poles and the flywheel?
Replies: 2
Views: 206
Posted By Wirepuller38

Will the pergola be pre-built or will it be built...

Will the pergola be pre-built or will it be built on site? If pre-built, be aware of the requirements to get it to your desired location on the lawn.
Showing results 1 to 25 of 200
 


 
Forum Jump