Search: Posts Made By: Caddraftsman
Showing results 1 to 3 of 3
Search took 0.01 seconds.
Replies: 13
Views: 3,180
Posted By Caddraftsman

If you a 1" radius, then it gets a lot trickier...

If you a 1" radius, then it gets a lot trickier to where you would take a solid piece of wood and cut the radius piece out of it and join it to your bending pieces. Either way, it's a pretty...
Replies: 13
Views: 3,180
Posted By Caddraftsman

Cool Beth, Depending on how much woodworking...

Beth,

Depending on how much woodworking experience you have, you could always take 1/8" strips of solid wood and bend it around the countertop, laminate the top and then put a decorative edge by...
Replies: 13
Views: 3,180
Posted By Caddraftsman

If I may offer a suggestion

Since you're new at this, I would run what is called a "build up" around the front perimeter and sides with strips of 3" wide P.B. Where the curves are, you'll need to determine how much coverage...
Showing results 1 to 3 of 3


 
Forum Jump