Search: Posts Made By: gejandsons
Showing results 1 to 25 of 118
Search took 0.01 seconds.
Replies: 11
Views: 2,868
Posted By gejandsons

If only a hot pair of wires are run to the...

If only a hot pair of wires are run to the ceiling box you could not cut the light off. So you run another pair of wires to the light switch. one end will be connected to the (black)hot wire in the...
Replies: 11
Views: 2,868
Posted By gejandsons

Determine which wires are hot with the switch on...

Determine which wires are hot with the switch on & off, using a test light or multimeter & post the results.
Replies: 3
Views: 1,966
Posted By gejandsons

If you cabinets are like mine you'll have a...

If you cabinets are like mine you'll have a microwave or something near the end. Changing the paint at the end of the upper & lower cabinets or at the top of the header on the slider would work.
10-19-08, 07:03 PM
Replies: 2
Views: 6,183
Posted By gejandsons

Sounds like a leaky roof to me. If the blown...

Sounds like a leaky roof to me.
If the blown insulation is damp, you'll have to dry it out.
Place a piece of poly 10 x 10 laying flat in the area that was damp & see if rain puddles on it.
Forum: Water Heaters
10-19-08, 06:57 PM
Replies: 4
Views: 1,065
Posted By gejandsons

The cold water inlet is near the bottom or has a...

The cold water inlet is near the bottom or has a tube internally that routes the cold water to the bottom of the tank.
The hot water is drawn off the top through the hot water outlet. Any air...
Replies: 11
Views: 2,868
Posted By gejandsons

The switch leg is not always the correct color. ...

The switch leg is not always the correct color.
Could be a three way.
Replies: 4
Views: 5,556
Posted By gejandsons

A good friend of mine installed snap together...

A good friend of mine installed snap together wood laminate without a moisture barrier & soon found bubbled up places in the floor.
Those bubbles had water puddles under them.
Do plenty of research...
Replies: 2
Views: 1,547
Posted By gejandsons

Call and cancell the order or change the order....

Call and cancell the order or change the order. Even if you have to pay a restocking fee it will be easier tha trying to rip the 6x6 down to a 4x4.
Replies: 3
Views: 1,747
Posted By gejandsons

When you remove the cover plate that covers the...

When you remove the cover plate that covers the clutch, it will expose the port that aligns with a slot in the bar through which the oil is pumped.
Sometimes dirt & saw dust plug this port. With the...
Replies: 4
Views: 1,945
Posted By gejandsons

If the float is floating & the needle valve is...

If the float is floating & the needle valve is going up& gas is leaking then the needle or seat is bad.
10-17-08, 11:35 PM
Replies: 7
Views: 1,277
Posted By gejandsons

Either the float valve or the flapper valve can...

Either the float valve or the flapper valve can cause this.
Replies: 6
Views: 8,991
Posted By gejandsons

Check to see if the plug is firing when you pull...

Check to see if the plug is firing when you pull the starter rope. If it is , then it is a gas problem.
07-02-08, 06:48 PM
Replies: 7
Views: 1,314
Posted By gejandsons

Was the fan & light on the old one controlled by...

Was the fan & light on the old one controlled by two seperate switces?
You'll need a test light to figure out which one is hot & which switch controls it.
07-02-08, 06:44 PM
Replies: 4
Views: 1,750
Posted By gejandsons

Thermostats have a swing from 3 to 5 degrees. If...

Thermostats have a swing from 3 to 5 degrees. If it is set on 77 it may not come on at 79.
Replies: 2
Views: 10,314
Posted By gejandsons

Most owner's manuals have a parts diagram that...

Most owner's manuals have a parts diagram that will show enough info so you can figure out the way to remove it.
07-02-08, 06:12 PM
Replies: 4
Views: 1,502
Posted By gejandsons

Use a utility knife to cut the putty / caulk at...

Use a utility knife to cut the putty / caulk at the edge of the doors
Replies: 1
Views: 1,559
Posted By gejandsons

Count the rounds as you turn each one tothe right...

Count the rounds as you turn each one tothe right till it stops.
Record this info. You can now adjust to your hearts desire to try to get it to run better. If it fails, you can return to the way it...
Replies: 14
Views: 3,770
Posted By gejandsons

I'm not sure you'll find tie rod ends on the rear...

I'm not sure you'll find tie rod ends on the rear of your car. But dry rubber will sometimes cause creaks that can be eliminated with spray silicone.

regards,
John 3:16
Replies: 3
Views: 1,418
Posted By gejandsons

The gas likely leaked into the crankcase while...

The gas likely leaked into the crankcase while the engine was not running. This is caused by a faulty needle or seat attached to the float. As long as the engine is running it will burn the gas...
Replies: 9
Views: 1,757
Posted By gejandsons

I fish tools out of oil wells for a living. ...

I fish tools out of oil wells for a living.
Without being able to see exactly what you have, it will be hard to help. you can fabricate something shaped similar to a cork screw to catch the wire. It...
Replies: 9
Views: 1,757
Posted By gejandsons

If the PVC broke off relatively smooth, you can...

If the PVC broke off relatively smooth, you can reattach by using the same size pipe with a coupling on the lower end with some rain or shine type glue inside the coupling. Lower in into the well &...
Replies: 3
Views: 1,322
Posted By gejandsons

Kingfisher has been out of production fo sometime...

Kingfisher has been out of production fo sometime now, except for afew built in 2004. They made several different models in the 80's. Even a few Fish/Ski models. You'll have to find another boat like...
Replies: 1
Views: 1,329
Posted By gejandsons

All flat roofs have a small amount of puddling....

All flat roofs have a small amount of puddling. If it is not leaking now, walking on it to repair the puddle will likely cause a leak.
Replies: 9
Views: 1,757
Posted By gejandsons

What type of pipe? iron, PVC? What size casing...

What type of pipe? iron, PVC?
What size casing is the pipe in?
Replies: 3
Views: 1,308
Posted By gejandsons

You may have a broken spring. Release the...

You may have a broken spring.
Release the emergency release & try to raise the door by hand.
It should raise with a small amount of effort if a spring is not broken.
Showing results 1 to 25 of 118
 


 
Forum Jump