Search: Posts Made By: twerkema
Showing results 1 to 8 of 8
Search took 0.01 seconds.
Replies: 1
Views: 1,593
Posted By twerkema

Lower floor renovation

We're updating our downstairs. There's an area we'd like to make into an open living space. It is split level, unfortunately, so only so much can be done. We need to add a bath, kitchenette, and...
Replies: 4
Views: 5,716
Posted By twerkema

Ok. Thanks. Not sure if we will, but wanted to...

Ok. Thanks. Not sure if we will, but wanted to ask. We are getting 5/4 and planing it as needed. Since it's s3, it shouldn't need too much.
Replies: 4
Views: 5,716
Posted By twerkema

Ok. Those reasons make sense. Is there a reason...

Ok. Those reasons make sense. Is there a reason you shouldn't do a roundover on top with something more decorative on the bottom half?
Thanks.
Replies: 4
Views: 5,716
Posted By twerkema

Front of stair tread always a bullnose? Other tips?

Is the front and return edges of a stair tread always a bullnose? We are building the treads ourselves from S3 lumber and can make them any way we choose. Is there a reason for the bullnose?

We've...
09-15-09, 09:48 AM
Replies: 3
Views: 2,793
Posted By twerkema

Thank you very much for the reply. I'm probably...

Thank you very much for the reply. I'm probably overly paranoid that the underside will show during normal use and that is why I'm considering staining it.

My fear is that I will do something...
09-14-09, 08:20 PM
Replies: 3
Views: 2,793
Posted By twerkema

stain table and slides?

I'm refinishing a vintage oak table and am ready to apply stain. I just realized that I have no idea what to do with the underside of the table top. The wood is red oak, and I am staining it a deep...
Replies: 2
Views: 1,266
Posted By twerkema

Thanks for your response Arkon. I did a...

Thanks for your response Arkon.

I did a little more reading online and found that a router can be used to make a clean edge, as long as I use a guide. I'm not sure which would be better, a...
Replies: 2
Views: 1,266
Posted By twerkema

Question Transition Molding Inlay

We recently laid/had someone lay a laminate floor throughout our downstairs. Unfortunately, our installer installed several transition moldings and then ran out. By the time we ordered more, he...
Showing results 1 to 8 of 8


 
Forum Jump