Search: Posts Made By: tkvpice
Showing results 1 to 11 of 11
Search took 0.01 seconds.
Replies: 1
Views: 3,921
Posted By tkvpice

calcium buildup in boiler

I have a raypak copper boiler installed 2 seasons ago. water supply has a lot of calcium and lime, everything plugs up. it recently started acting up, and I know its because the line in the heat...
Replies: 1
Views: 765
Posted By tkvpice

ok figured it out, apparantly the water valve...

ok figured it out, apparantly the water valve went bad and was not refilling, after I tapped on it I could hear the system start to fill, I now have water to the rads. Guess I'll need to pick one up...
Replies: 1
Views: 765
Posted By tkvpice

plugged lines?

have an old house(1938) last year posted problems with getting rads to flow. one of you guys suggersted I bring the water pressure up in the system and see if the baseboards started to flow. tried...
Replies: 3
Views: 1,206
Posted By tkvpice

no didn,t touch the sensors they are green and...

no didn,t touch the sensors they are green and appear to be ok. I unpluged the harness to the limit switch and then the door will run in both directions, but only a few inches, then it stops and...
Replies: 3
Views: 1,206
Posted By tkvpice

sears opener will not close

I have a craftsman garage door opener about 15 years old recently the drive gear wore out. was ground down to nothing. ordered a new one and replaced this morning, but now the door will not go...
Replies: 12
Views: 1,926
Posted By tkvpice

ok raised system pressure to 18 psi two...

ok raised system pressure to 18 psi two baseboards (furthest from the boiler) began to flow, but incredibly slow, they're both about 8' long after 1 hour they are hot at the inlets and about body...
Replies: 12
Views: 1,926
Posted By tkvpice

it's a 0066b little guy. it's really secondary...

it's a 0066b little guy. it's really secondary heat, old house been added on to a number of times, so I installed additional vents to an existing hvac system to heat and cool the whole place except...
Replies: 12
Views: 1,926
Posted By tkvpice

gotcha, read up on the raypack the manual said...

gotcha, read up on the raypack the manual said max head 8.0 max flow 5.3 it also indicates that if the overall flow is inadequate then a secondary pump should be installed. but not sure where the...
Replies: 12
Views: 1,926
Posted By tkvpice

yea that makes sense, and your right about the...

yea that makes sense, and your right about the expansion tank, problem is, with the old cast iron pipeing and how the boiler is installed its almost impossible to repipe without doing some major...
Replies: 12
Views: 1,926
Posted By tkvpice

system pressure is at 14# constant

system pressure is at 14# constant
Replies: 12
Views: 1,926
Posted By tkvpice

Boiler flow problem

I have an old system in the house (1938) single pipe system with diverter tee's the old cast iron type main line is 1" reduces to 1/2" on the risers to the rads. when I purchased the house in 91 I...
Showing results 1 to 11 of 11


 
Forum Jump