Search: Posts Made By: foxyroxy111298
Showing results 1 to 9 of 9
Search took 0.01 seconds.
Replies: 6
Views: 6,109
Posted By foxyroxy111298

Well, it says that cable goes to the choke, which...

Well, it says that cable goes to the choke, which is wierd.. this throttle cable connects to the handle bars in the center. Im guessing it connects down to the tank. i think its some throttle control...
Replies: 6
Views: 6,109
Posted By foxyroxy111298

Oh, no this is a throttle control lever that...

Oh, no this is a throttle control lever that attached to the handles of the actual tiller and connects to the other side (im guessing) of the lever that the #692208 attachs to, but on on the other...
Replies: 6
Views: 6,109
Posted By foxyroxy111298

thanks for the diagram. I think this carb is...

thanks for the diagram. I think this carb is missing half its parts. I made a list from the parts diagram and im missing govenor rods, choke rod, and bell crank, plus one of those springs.. im sure...
Replies: 6
Views: 6,109
Posted By foxyroxy111298

Spring Locations for Gilson 1580 tiller

Hi I have a montgomery ward/gilson tiller, model # I have is 1580I, serial 57x 172 38 for the tiller
and the engine briggs:

100202-0145-01

It was a project and they had everything taken apart...
Replies: 8
Views: 4,392
Posted By foxyroxy111298

how can i keep the pickup tube to stay in? any...

how can i keep the pickup tube to stay in? any idea is appreciated. thanks
Replies: 8
Views: 4,392
Posted By foxyroxy111298

I do notice the smaller of the pickup tubes isnt...

I do notice the smaller of the pickup tubes isnt staying in. least when i go to remove the tank again to double check. I dont know if it comes off while im trying to start it. Is there a putty or...
Replies: 8
Views: 4,392
Posted By foxyroxy111298

the model # I have is 1580I, serial 57x 172 38...

the model # I have is 1580I, serial 57x 172 38 for the tiller
and the engine

100202-0145-01

Also, the throttle control spring lever was disconnected and ive had a hard time trying to figure...
Replies: 8
Views: 4,392
Posted By foxyroxy111298

im having a hard time finding those posts, maybe...

im having a hard time finding those posts, maybe im searching wrong?
Replies: 8
Views: 4,392
Posted By foxyroxy111298

Briggs engine wont suck up fuel into chamber

Hi ! I have a montgomery ward/gilson tiller, prob from the 60's the problem is that this carb doesnt have a primer bulb. like my snow thrower does, so it must you some suction from the engine to draw...
Showing results 1 to 9 of 9


 
Forum Jump