Search: Posts Made By: H2Ohhhhh
Showing results 1 to 6 of 6
Search took 0.01 seconds.
Replies: 8
Views: 38,047
Posted By H2Ohhhhh

I did look into renting a core drill, but they...

I did look into renting a core drill, but they all seemed to be designed for cutting vertical cores and as far as I could tell they all required wetting, which would make a really big mess. (It's not...
Replies: 8
Views: 38,047
Posted By H2Ohhhhh

I already have a couple of hammer drills, but...

I already have a couple of hammer drills, but that doesn't seem like the right tool for this job. I also have a couple of air hammers with chisel bits, so making a hole in the wall is not a problem....
Replies: 8
Views: 38,047
Posted By H2Ohhhhh

Installing a dryer vent in a concrete block wall

The article on installing a dryer vent just says to cut a 4" hole in the wall with a hole saw, but the wall I need to cut that hole through is made out of concrete blocks. I've looked high and low...
07-04-09, 03:15 PM
Replies: 2
Views: 851
Posted By H2Ohhhhh

That depends on your plumbing. Can you describe...

That depends on your plumbing. Can you describe where the water goes after it leaves the filter and what valves are involved?
Replies: 4
Views: 1,103
Posted By H2Ohhhhh

There are epoxy-based sealers available for...

There are epoxy-based sealers available for resurfacing pool decks. Try googling for pool deck epoxy sealant.
06-28-09, 10:11 AM
Replies: 3
Views: 2,214
Posted By H2Ohhhhh

You do know that it's a left-hand thread, right?...

You do know that it's a left-hand thread, right? Most of them are, at least. You can always tell by which way the motor runs. They're always threaded in such a way that the normal operation of the...
Showing results 1 to 6 of 6


 
Forum Jump