Search: Posts Made By: kenwulfe
Showing results 1 to 8 of 8
Search took 0.01 seconds.
10-31-11, 08:23 AM
Replies: 16
Views: 3,852
Posted By kenwulfe

Spoke with the Co. where I purchased the...

Spoke with the Co. where I purchased the controller, and they stated that it has a built in relay.

I am either not seeing or missing where it indicates how to set this in the instructions.
...
10-28-11, 11:16 AM
Replies: 16
Views: 3,852
Posted By kenwulfe

Ok - battery test done. SSR gets signal (even has...

Ok - battery test done. SSR gets signal (even has an LED that indicated such) and the coils started heating.

So, issue is with the controller or a setting on the controller.
10-28-11, 10:38 AM
Replies: 16
Views: 3,852
Posted By kenwulfe

In the process of testing now. I am getting no...

In the process of testing now. I am getting no voltage to 6 and 7 on the PID, but the ATU setting is at 0. I also see that there is an STU setting, but nothing in the manual for it.

When I set the...
10-27-11, 11:14 AM
Replies: 16
Views: 3,852
Posted By kenwulfe

I had a thought.... What if the PID is not...

I had a thought.... What if the PID is not sending the signal to the SSR to open?

I am going to test connections and such later today or tomorrow. I will post results.

Thank you for assisting...
10-27-11, 09:19 AM
Replies: 16
Views: 3,852
Posted By kenwulfe

Oh, and the model is: CXTG-3000-FK02-M*AN-NN

Oh, and the model is:

CXTG-3000-FK02-M*AN-NN
10-27-11, 05:43 AM
Replies: 16
Views: 3,852
Posted By kenwulfe

Yes, I have a multimeter. I will get a...

Yes, I have a multimeter.

I will get a higher ampere switch, but the 20amp switch I have would not explain no heat at all. Even getting 4 amperes (or even 1 ampere) per coil, there should be some...
10-26-11, 06:21 PM
Replies: 16
Views: 3,852
Posted By kenwulfe

It is a type K thermocouple, regulated for up to...

It is a type K thermocouple, regulated for up to 2600 degree F temps.
The link to the digital controller user manual is here:
http://www.dinicoinc.com/uploads/1.pdf
...however, it is incomplete....
10-26-11, 01:07 PM
Replies: 16
Views: 3,852
Posted By kenwulfe

Rewiring and digitizing an old GARE kiln

Greetings all. Long time DYIer from car to home improvements... This week,however, I have found something that has me stumped. I am rewiring an old GARE kiln. 240v, 30a, single phase. The kiln was...
Showing results 1 to 8 of 8


 
Forum Jump