Search: Posts Made By: Vizslafan16
Showing results 1 to 10 of 10
Search took 0.01 seconds.
06-02-14, 06:30 PM
Replies: 19
Views: 21,240
Posted By Vizslafan16

Thanks Wyr! I appreciate the additional...

Thanks Wyr! I appreciate the additional diagnostic advice/steps. I put in a new control board and can proudly say I have AC. Before putting in the board i did take your advice on verifying no shorts...
06-01-14, 10:56 AM
Replies: 19
Views: 21,240
Posted By Vizslafan16

Took off the board today and found trace bad on...

Took off the board today and found trace bad on the common wire.
05-31-14, 09:57 AM
Replies: 19
Views: 21,240
Posted By Vizslafan16

Just an update to possibly spur any additional...

Just an update to possibly spur any additional ideas. I replaces thermostat wiring to the thermostat and also replaced the transformer. I now verified there is 24vac coming out of transformer and...
05-29-14, 06:26 PM
Replies: 19
Views: 21,240
Posted By Vizslafan16

Hopefully these pictures will work. Model of...

Hopefully these pictures will work. Model of furnace is RGPK-10EAMER. I have one picture of the board and the second picture showing the test results of zero vac between r and c. From the looks of it...
05-29-14, 01:31 PM
Replies: 19
Views: 21,240
Posted By Vizslafan16

I do have 2 out of the 3 green lights lit on the...

I do have 2 out of the 3 green lights lit on the control board when the blower door safety switch is pressed in. Energy saver switch is installed by the electric company and is described as a switch...
05-29-14, 11:16 AM
Replies: 19
Views: 21,240
Posted By Vizslafan16

Just an update on a few things. I checked the...

Just an update on a few things. I checked the voltage on the contractor this morning and there was zero volts. I then went back into the wiring splice before the contractor where the energy savers...
05-28-14, 09:50 PM
Replies: 19
Views: 21,240
Posted By Vizslafan16

The voltage reading was taken at the wire...

The voltage reading was taken at the wire connection
05-28-14, 09:45 PM
Replies: 19
Views: 21,240
Posted By Vizslafan16

I do not get voltage on the t1 and t2 side.

I do not get voltage on the t1 and t2 side.
05-28-14, 09:39 PM
Replies: 19
Views: 21,240
Posted By Vizslafan16

Thanks for the quick reply. I did measure the...

Thanks for the quick reply. I did measure the voltage and it has a bit over 20vac. I did also take voltage on the 240 line coming in at the compressor and that checks out at 240vac. So does that...
05-28-14, 09:15 PM
Replies: 19
Views: 21,240
Posted By Vizslafan16

AC compressor not turning on with thermostat

I have a honeywell 6450 thermostat, rheem criterion ii plus gas furnace and a rheem classic ac unit. I tried to start up the air conditioner for the season by turning on cooling on the thermostat....
Showing results 1 to 10 of 10


 
Forum Jump