Search: Posts Made By: BillMacDonald
Showing results 1 to 6 of 6
Search took 0.01 seconds.
Replies: 13
Views: 5,828
Posted By BillMacDonald

Thanks so much for putting your time and thoughts...

Thanks so much for putting your time and thoughts into this. Just to throw out a couple of ideas...

Is it possible to power the zone valve by hooking up a new zvc panel inside the kitchen zone...
Replies: 13
Views: 5,828
Posted By BillMacDonald

Bigger picture... The house has 5 zones for the...

Bigger picture...
The house has 5 zones for the radiant floor heat. The bottom panel controls the 3 on the west side of the house. Those zone valves are in the boiler room below the panels. The...
Replies: 13
Views: 5,828
Posted By BillMacDonald

44030 Here's both panels and below are the...

44030
Here's both panels and below are the pumps. I assume one goes to domestic hot water and the other to the radiant floor pipes.
44031
Replies: 13
Views: 5,828
Posted By BillMacDonald

The Taco installation diagram shows 4 wires with...

The Taco installation diagram shows 4 wires with the 2 yellow (L1, L2 hot) going to #1 & 2 of the panel for that zone valve and the 2 red (end switch) going to #3, 4. The way it's wired now the reds...
Replies: 13
Views: 5,828
Posted By BillMacDonald

The 4 expansion connector wires are connected to...

The 4 expansion connector wires are connected to the other expansion connectors on the zvc mounted just below the one in the photo.
Replies: 13
Views: 5,828
Posted By BillMacDonald

Need help wiring zone valve to taco zvc

Hello,
I am hoping for some guidance on wiring a 4-wire honeywell 8043E zone valve to a taco zvc404exp. The information I've found from taco's site is clear how I should do this, BUT I've only got...
Showing results 1 to 6 of 6


 
Forum Jump